Laserfiche WebLink
SpectrAlert Advance Specifications <br /> -- - . <br /> General <br /> SpectrAlert Advance strobes and horn strobes shall mount to a standard 4 x 4 x 1'h-inch back box,4-inch octagon back box,or double- <br /> gang back box.Two-wire products shall also mount to a single-gang 2 x 4 x 17/8-inch back box.A universal mounting plate shall be used for <br /> mounting ceiling and wall products.The notification appliance circuit wiring shall terminate at the universal mounting plate.Also,SpectrAlert <br /> Advance products,when used with the Sync•Circuit'"Module accessory,shall be powered from a non-coded notification appliance circuit <br /> output and shall operate on a nominal 12 or 24 volts.When used with the Sync•Circuit Module,12-volt-rated notification appliance circuit <br /> outputs shall operate between 9 and 17.5 volts;24-volt-rated notification appliance circuit outputs shall operate between 17 and 33 volts. <br /> Indoor SpectrAlert Advance products shall operate between 32 and 120 degrees Fahrenheit from a regulated DC or full-wave rectified <br /> unfiltered power supply.Strobes and horn strobes shall have field-selectable candela settings including 15, 15/75,30,75,95,110,115,135, <br /> 150, 177,and 185. <br /> Strobe <br /> The strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and shall be approved for fire protective service. <br /> The strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for <br /> visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light shall consist of a xenon flash <br /> tube and associated lens/reflector system. <br /> Hom Strobe Combination <br /> The horn strobe shall be a System Sensor SpectrAlert Advance Model listed to UL 1971 and UL 464 and shall be approved for <br /> fire protective service.The horn strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with <br /> Disabilities Act requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe light <br /> shall consist of a xenon flash tube and associated lens/reflector system.The horn shall have three audibility options and an option to switch <br /> between a temporal three pattern and a non-temporal(continuous)pattern.These options are set by a multiple position switch.On four-wire <br /> products,the strobe shali be powered independently of the sounder.The horn on horn strobe models shall operate on a coded or non-coded <br /> power supply. <br /> Syrnchronization Module <br /> The module shall be a System Sensor Sync•Circuit model MDL listed to UL 464 and shall be approved for fire protective service.The module <br /> shall synchronize SpectrAlert strobes at 1 Hz and horns at temporal three.Also,while operating the strobes,the module shall silence the horns <br /> on horn strobe models over a single pair of wires.The module shall mount to a 411/16 x 411/16 x 21/S-inch back box.The module shall also . <br /> control two Sryle Y(class B)circuits or ohe Sryle Z(class A)circuit.The module shall synchronize multiple zones.Daisy chaining two or more <br /> synchronization modules together will synchronize all the zones they control.The module shall not operate on a coded power supply. <br /> - . • <br /> Standard Operating Temperature 32°F to 120°F(0°C to 49°C) <br /> Humidity Range 10 to 93%a non-condensing <br /> Strobe Fiash Rate 1 flash per second <br /> Nominal Voltage Regulated 12 DC/FWR or regulated 24 DC/FWR' <br /> Operating Voltage Range2 8 to 17.5 V(12 V nominal)or 16 to 33 V(24 V nominal) <br /> InputTerminal Wire Gauge 12 to 18 AWG <br /> Ceiling-Mount Dimensions(including lens) 6.8""diameter x 2.5"high(173 mm diameter x 64 mm high) <br /> Ceiling-Mount Back Box Skirt Dimensions(BBSC-2,BBSCW-2) 7 1"diameter x 2.2"high(180 mm diameter x 57 mm high) <br /> Ceiling-MountTrim Ring Dimensions(sold as a 5 pack)(TRC-HS, 6.9"diameter x 0.35"high(175 mm diameter x 9 mm high) <br /> TRCW-HS) <br /> Notes: <br /> 1 Full Wave Rectified(FWR)voltage is a non-regulated,time-varying power source that is used on some power supply and panel outputs. <br /> 2.P,S,PC,and SC products will operate at 12 V nominal only for 15 and 15/75 cd. <br /> AVDS00501 <br />