14-15344 - Laserfiche WebLink

Browse Search

SpectrAlert Advance Specifications General SpectrAlert Advance horns,strobes,and horn strobes shall mount o a standard 4 x 4 x t Yz-inch back box,4-inch octagon back box,or double-gang back box.Twawire producu shall also mount to a single-gang 2 x 4 x �/a-inch back box.A universal mounting plate shall be used for mounting ceiling and wall products.lhe notification appliance circuit wiring shall termi ate at the universal mounti�g plate.Also,SpectrAlert Advance producu,when used with the Sync{ircuit"Module accessory,shall be powered from a non oded notification appliance circuit output and shall operate on a nominal 12 or 24 volts. When used with the SynaCircuit Module,l2-volt-rated notificatio appliance circu(t outputs shall operate between 9 and 17.5 volts;24-volt-rated notification appliance circuit outputs shall operate between 17 and 33 volu.I door SpectrAlert Advance products shall operate between 32 and 120 degrees Fahrenheit from a regulated DC or full-wave rec[ified unfiltered power supp Strobes and horn strobes shall have field-selectable candela settings including 15,15/75,30, 75,95,110,115,135,150,177,and 185. Strobe The svobe shall be a System Sensor SpectrAlert Advance Model Iisted to UL 1971 and shall be approved for fire protective service.The strobe shall be wired as a prfmary-signaling notification appliance and comply w h the Americans with D(sabilitfes Act requirements for visible signaling appliances,flashing at 1 Hz over the strobe's entire operating voltage range.The strobe li ht shall conslst of a xenon flash tube and associated lens/reflector rystem. Horn Strobe Combination The hom strobe shall be a System Sensor Spec[rAlert Advance M del listed to UL 1971 and UL4b4 and shall be approved forfire protective service.The horn strobe shall be wired as a primary-signaling notification appl ance and comply with the Americans with Disabilities Act requlrements for visible signaling appliances,flashing at 1 Hz overthe strobe's entire operating volt ge range.The strobe Ifght shali consist of a xenon flash tube and associated lens/reflector rystem.The horn shall have three audibility options and an optio to switch between a temporal three-pattern and a non-temporal(continuous)pattern.These options are set by a multiple position switch.On four-wire produ s,the strobe shall be powered independently of the sounder.The hom on horn strobe models shall operate on a coded or non-coded power supply. Synchronization Module The module shall be a System Sensor SynaCircuit model MDL list to UL 464 and shall be approved for fire protective service.The module shall synchronize SpectrAlerc strobes at 1 Hz and horns at temporal three.Also,whil operating the strobes,the module shall silence the horns on horn strobe models over a single pair of wiresThe module shall mount to a 4��/,e x 4��/�b x 2� -inch back boxThe module shall also control two StyleY(class B)circuits or one Style Z (class f�circuftThe module shall synchronize multiple zones.Dai chaining two or more synchronization modules together will synchronize all the zones they control.The module shall not operate on a coded power supply. Standard Operating Tempereture 32°F to 120°F(0°C to 49°C) Humidity Range 10 to 9355 non-condensing Strobe Flash Rate 1 flash per second • Nominal Voltage Regulated 12 DC/FWR or regulated 24 DGFWR' Operating Voltage Rangez 8 to 175 V(12 V nomina�or 16 to 33 V(24V nomina� InputTerminal Wire Gauge 12 to 18 AWG Ceiling-Mount Dimensions(including lens) 6.8"diameter x 2.5"high(173 mm diameter x 64 mm high) Wall-Mount Dimensions(including lens) 5.6"L x 4.7"W x 2.5"D(142 mm L x 119 mm W x 64 mm D) Horn Dimensions 5.6"L x 4.7"W x 13"D(142 mm L x 119 mm W x 33 mm D) Wall-Mount Back Box Skirt Dimensions(BBS-2,BBSW-2) 5.9"L x S.0"W x 22"D(151 mm L x 128 mm W x 56 mm D) Ceiling-Mount Back Box Skirt Dimensions(BBSC-2,BBSCW-2 71"d(ameter x 22"high(180 mm diameter x 57 mm high) Wall-MountTrim Ring Dimensions(sold as a 5 pack)(TR-HS, RW-HS) 5.7"L x 4.8"W x 035"D(145 mm L x 122 mm W x 9 mm D) Ceiling-MountTrim Ring Dimensions(sold as a 5 pack)(TRC- S,TRCW-HS) 6.9"diameter x 035"high(175 mm diameter x 9 mm high) Notes: 1.Full Wave Rectffied(FWR)voltage is a non-regulated,time-varyi g power source that is used on some power supply and panel outputs. 2.P,S,PC,and SC products will operate at 12 V nominal only for 1 and 15/75 cd. I I I I AOSO395-007 I; I