16-17524 - Laserfiche WebLink

Browse Search

. . - ~'''�� ��T�� ERD � Continue upslope in a similar manner,maintaining minimum 3-inch side-laps and minimum 6-inch end-laps. Fasten 6- inch o.c.in the laps and 12-inch o.c.in two,equally spaced,staggered center rows in the field. Ensure all end laps are staggered at least 3-feet apart. 6.3.4.2 Standard Installation with Double Layer,2:12<roof slope<4:12 ' Starting at the eave,fasten the eave edge and 6-inch wide end-laps 6-inch o.c. Fasten in the field of the roll 12-inch o.c,in two,equally spaced,staggered center rows. Continue upslope in a similar manner,with minimum 28.5-inch side-laps and minimum 6-inch end-laps. Fasten 6-inch o.c. along the low edge and end laps and 12-inch o.c. in two, equally spaced, staggered center rows in the field. Ensure all end laps are staggered at least 3-feet apart. 6.4 Ti�er PawTM'Roof Deck Protedion: 6.4.1 Install Tiger PawT""Roof Deck Protection in compliance with manufacturer's published installation instructions and the requirements for ASTM D226,Type I and II underlayments in FBC Sections 1507 for the type of prepared roof covering to be installed. . 6.4.2 Fasteners shall be 1-inch diameter plastic-capped corrosion resistant nails or 1-inch diameter plastic-capped,corrosion resistant staples. 6.4.3 Optional, or if required by the Authority Having Jurisdiction: Install a leak barrier of Liberty'"" SBS Self-Adhering Base/Ply Sheet;StormGuard� Film Surfaced Leak Barrier; UnderRooP"" 2 Polyester-Surfaced Leak Barrier; UnderRoof'"' HT High Temperature Leak Barrier; WeatherWatch� Mineral Surfaced Leak Barrier or WeatherWatch� XT Mat ' Surfaced Leak Barrier at vulnerable leak areas,including but not limited Yo eaves,valleys,rakes,skylights and dormers. At eaves and valleys, install the leak barrier prior to installation of the underlayment. Along the rake, install the underlayment, leaving 6 to 8-inch of the deck exposed, and then install the leak barrier over the underlayment and exposed decking. At other areas,install the leak barrier over the underlayment. 6.4.4 For non-tile roof installations: 6.4.4.1 Standard Installation with Single Layer;roof slope>4:12 Starting at the eave,fasten the eave edge and 6-inch wide end-laps 6-inch o.c. Fasten in the field of the roll 12-inch I o.c.in two,equally spaced,staggered center rows. Continue upslope in a similar manner,maintaining minimum 3-inch side-laps and minimum 6-inch end-laps. Fasten 6- inch o.c.in the laps and 12-inch o.c.in two,equally spaced,staggered center rows in the field. Ensure all end laps are staggered at least 3-feet apart. 6.4.4.2 Standard Installation with Double Layer;2:12<roof slope<4:12 Starting at the eave,fasten the eave edge and 6-inch wide end-laps 6-inch o.c. Fasten in the field of the roll 12-inch o.c.in two,equally spaced,staggered center rows. Continue upslope in a similar manner,with minimum 22.5-inch side-laps and minimum 6-inch end-laps. Fasten 6-inch o.c. along the low edge and end laps and 12-inch o.c. in two, equally spaced, staggered center rows in the field. Ensure all end laps are staggered at least 3-feet apart. 6.5 StormSafe'""Anchor Sheet: 6.5.1 StormSafeT"'Anchor Sheet is limited to use as a mechanically attached base layer in 2-ply underlayment systems. 6.5.2 Fasteners shall be 1-inch diameter plastic-or steel-capped corrosion resistant nails; corrosion-resistant nails& 1-5/8- inch tin-caps;or Drill-Tec screws and plates. 6.5.3 For tile roof installations: Installation is governed by the FRSA/TRI April 2012(04-12)Installation Manual,5th Edition(Revised). Use is limited to � the mechanically attached base sheet in the two-ply system beneath UnderRoofl"' 2 Polyester-Surfaced Leak Barrier. The attachment requirements for StormSafe"" Anchor Sheet shall be adjusted from those in Appendix A,Table 1 of FRSA/TRI April 2012 (04-12),5`h Edition (Revised)to be proportionate to the width of the StormSafe'"" Anchor Sheet product. � 6.5.4 For non-tile roof installations: Starting at the eave,fasten the eave edge and 6-inch wide end-laps 6-inch o.c. Fasten in the field of the roll 12-inch o.c.in two,equally spaced,staggered center rows. Exterior Research and Design,LLC. Evaluation Report 01506.03.12-RS Certificate of AuthorizaYion N9503 FL15487-RS Revision 5:04/02/2015 Page 4 of 5