16-17113 - Laserfiche WebLink

Browse Search

• Insulation C303.2.1 Envelope Exterior insulation is protected from damage with � � � a protective material.Verification for exposed foundation insulation may need to occur during Foundation Inspection. Insulation C402.2.1 Envelope Insulation intended to meet the roof insulation � � � requirements cannot be installed on top of a suspended ceiling.Mark this requirement compliant if insulation is installed accordingly Controls C405.2.4 Exterior Lighting Automatic lighting controls for exterior lighting � � � installed. Wattage C405.6 Exterior Lighting Exterior grounds lighting over 100 W provides>60 � � ❑ Im/W unless on motion sensor or fixture is exempt Watta e from scope of code or from extemal LPD. 9 C405.6.2 Exterior Lighting Exterior lighting power is consistent with what is ❑ � � shown on the approved lighting plans, demonstrating proposed watts are less than or Controls equal to allowed watts. C405.2.2.1 Interior Lighting Automatic controls to shut off all building lighting � �I � installed in all buildings. Controls C405.2.1 1 Interior Lighting Independent lighting controls installed per � � � approved lighting plans and all manual conVols readily accessible and visible to occupants. Controls C405.2.1.2 Interior Lighting Lighting controls installed to uniformly reduce the � � � IighGng load by at least 50°/,. Controls C405.2.2.3 Interior Lighting Daylight zones provided with individual controls � � � that control the lights independent of general area lighting. Controls C405.2.3 Interior Lighting Sleeping units have at least one master switch at � � � the main entry door that controls wired luminaires and switched receptacles. Controls C405.2.2.2 Interior Lighting Occupancy sensors installed in required spaces. ❑ � � Controls C405.22.3 interior Lighting Primary sidelighted areas are equipped with ❑ ❑ � required lighting controls. Controls C405.2.2.3 Interior Lighting Enclosed spaces with daylight area under � � � skylights and rooftop monitors are equipped with required lighting controls. Controls C405.2.3 Interior Lighting Separate lighting control devices for specific uses � � � installed per approved lighting plans. Controls C405.3 Interior Lighting Fluorescent luminaires within odd numbered lamp � � � configurations that are with 10 feet center to center(if recess mounted)or are within 1 foot edge to edge(if pendant or surFace mounted) shall be tandem wired. Wattage C405.4 Interior Lighting Exit signs do not exceed 5 watts per face. ❑ � � Wattage C405.2.3 Interior Lighting Additional interior lighting power allowed for � � � special functions per the approved IighGng plans and is automatically controlled and separated from general lighting. Wattage C405.5.2 Interior Lighting Interior installed lamp and fixture lighting power is � ❑ � , consistent with what is shown on the approved lighting plans,demonstrating proposed watts are HVAC less than or equal to allowed watts. C403.2.4.5 Mechanical Freeze protection and snow/ice melting system � � � sensors for future connection to controls. HVAC C403.2.3 Mechanical HVAC equipment efficiency verified. � � � Air Leakage C402.4.5.1 Envelope Stair and elevator shaft vents have motorized � � � dampers that automatically close. Air Leakage C402.4.5.2 Envelope Outdoor air and exhaust systems have motorized � � � dampers that automatically shut when not in use and meet maximum leakage rates.Check gravity HVAC dampers where allowed. C403.2.5.1 Mechanical Demand control ventilation provided for spaces � � � >500 ft2 and>25 people/1000 ft2 occupant density and served by systems with air side economizer,auto modulating outside air damper control,or design airflow>3,000 cfm. EnergyGauge Summit0 Fla/Com-2014.TAM 2014-1.0 Compliant Software.Effective Date:June 30,2015 2/25/2016 I Page 9 of 13 ' I