37343 LAUREL HAMMOCK DR - Laserfiche WebLink

Browse Search

� Branch circuits for lighting and for appliances,including motor-operated appliances, shall be provided to supply , the loads computed in accordance with Section 220-3. In addition,branch circuits shall be provi'ded for specific loads not covered by Section 220-3 where required elsewhere in this Code and for dwelling unit loads-as specified in(c).i�� ' ; Y (a)Number of Branch Cnrcuits. The minimum number of branch circuits shall be determined from the total computed load and the size or rating of the circuits used. In all installations,the number of circuits sha11 be sufficient to supply the load served. In no case sha11 the load on any circuit exceed the maximum specified by Section 220-4. � � (b) I,oad Evenly Proportioned Among Branch CYrcuits. Where the load is computed on a j volt-amperes/square foot(0.093 m2) basis,the wiring system up to and including the branch-circiait panelboard(s) shall be provided to serve not less than the calculated load. This load.shall be evenl�y proportioned among multioutlet branch circuits within the panelboard(s). Branch-circuit overcurrent devices a.nd circuits need only be installed to serve the connected load. i ' (c)Dwelling Units. I � (1) Small-Appliance�ranch Circuits. In addition to the number of branch circuits required by I�ther parts of this section,two or more 20-ampere small-appliance branch circuits sha11 be provided for all rece�tacle outlets specified by Section 210-52(b). � � (B)�,aundry�ranch Circuits. In addition to the number of branch circuits required by other parts of this section, at least one additional 20-ampere branch circuit shall be provided to supply the laundry r i�epta.cle outlet(s)required by Section 210-52(fl. This circuit shall have no other outlets. �, (3) Bathroom Branch Careuits. In addition to the number of branch circuits required by other palrts of this section, at least one 20-ampere branch circuit sha11 be provided to supply the bathroom receptaclel outlet(s). : Such circuits shall have no other outlets. ' Exception: Where the 20-arnpere circuit supplies a single bathroom, outlets for other equipmen�t within the y same bathroom shall be pe�mitted to be supplied in accordance with Section 210-23(a). � FPN: See Examples D 1(a),D1(b),D2(b),and D4(a)in Appendix D. �', I ��210-52. IDwelling�7nit iteceptacle Outlets ' I Receptacle outlets required by this section sha11 be in addition to any receptacle that is part of a lin�hting fixture , or appliance, located within cabinets or cupboards, or located more than 51/z ft(1.68 m) above the�floor. Permanently installed elecixic baseboard heaters equipped with factory-installed receptacle outlets lor outlets • provided as a separate assembly by the manufacturer sha11 be permitted as the required outlet or ou.tlets for the wall space utilized by such permanently installed heaters. Such receptacle outlets shall not be co��.ected to the heater circuits. i � FPN:Listed baseboard heaters include instructions that may not permit their installation below receptacle outlets.�ic�+`"� ` i' (a) Genea�al Provisions. In every kitchen, family room, dining room, living room,parlor,library, d.en, sunroom, bedroom,recreation room, or similar room or area of dwelling units, receptacle outlets shall be ins�:alled in � accordance with the general provisions specified in(1)through(3). (1) Spacing. Receptacles shall be installed so that no point along the floor line in any wall space is more than 6 ft (1.83 m), measured horizontally, from an outlet in that space. Receptacle outlets shall, insofar as�racticable, be spaced equal distances apart.,��u �I � (B)�Vall Space. As used in this section, a wa11 space shall include the following: I � a. Any space 2 ft (610 mm) or more in width(including space measured around corners) and un�broken along � . i � � i