17-18480 - Laserfiche WebLink

Browse Search

, Insulation C402.2.1 Envelope Insulation intended to meet the roof insulation � � � requirements cannat be insta4led on top of a suspended ceiling.Mark this requirement compliant if insulation is installed accordingly. Controls C405.2.4 Exterior Lighting Automatic lighting controls for exterior lighting � � � installed. Contrbls C405.2.2.1 Interior Lighting Automatic controls to shut off all building lighting � � � installed in all buildings. Controls C405.2.1.1 Interior Lighting Independent lighting controls installed per � � � approved lighting plans and all manual controls readily accessible and visible to occupants. Controls C405.2.1.2 Interior Lighting Lighting controls installed to uniformly reduce the � � � i lighting load by at least 50%. � Controls C405.2.2.3 ' Interior Lighting Daylight zones provided with individual controls that control the lights independent of general area � � � '' lighting. , Controls C405.2.3 Interior Lighting Sleeping units have at least one master switch at � � � , the main entry doorthat controls wired luminaires and switched receptacles. Controls C405.2.2.2 Interior Lighting Occupancy sensors installed in required spaces. � � � Controls C405.2.2.3 Interior Lighting Primary sidelighted areas a�e equipped with � � � required lighting controls. Controis C405.2.2.3 Interior Lighting Enclosed spaces with daylight area under � � � skylights and rooftop monitors are equipped with required lighting controls. Controis C405.2.3 Interior Lighting Separate lighting control devices for specific uses � � � installed per approved lighting plans. Controls C405.3 Interior Lighting Fluorescent luminaires within odd numbered lamp � � � - configurations that are with 10 feet center to � center(if recess mounted)or are within 1 foot � . edge to edge(if pendant or surface mounted) � shall be tandem wired. Wattage C405.5.2 Interior Lighting Interior installed lamp and fixture lighting power is � � � consistent with what is shown on the approved ' lighting plans,demanstrating proposed watts are � less than or equal to ailowed watts. HVAC C403.2.4.5 Mechanical Freeze protection and snow/ice melting system � � � � sensors for future connection to controls. � HVAC C403.2.3 Mechanical HVAC equipment efficiency verified. � � � � � Air Leakage , C402.4.5.1 Envelope Stair and elevator shaft vents have motorized � � � dampers that automatically close. , Air Leakage C402.4.5.2 Envelope Outdoor air and exhaust systems have motorized � � � dampers that automatically shut when not in use and meet maximum leakage rates.Check gravity � dampers where allowed. I HVAC C403.2.8.1 Mechanical Piping Insulation exposed to weather is protected � � � from damage(due to sun,moisture,wind,etc.). HVAC C403.2.7 Mechanical HVAC ducts and plenums insulated. Where ducts � � � or plenums are installed in or under a slab, verification may need to occur during Foundation • Inspectian. HVAC C403.2.8 Mechanical Thermally ineffective panel surfaces of sensible � � � i heating panels have insulation>=R-3.5. i HVAC C403.2.7 Mechanical Ducts and plenums sealed based on static � � � pressure and location. HVAC C408.2.2.1 Mechanical Air outlets and zone terminal devices have means � � � � for air balancing. , HVAC C403.2.11 Mechanical Unenclosed spaces that are heated use only � � � . radiant heat. HVAC C403.2.4 1 Mechanical Heating and cooling to each zone is controlled by �. � � � a thermostat control. � HVAC C403.2.4.2 Mechanical Thermostatic controls have a 5"F deadband. � � � � HVAC C403.2.4.2 Mechanical Temperature controls have setpoint overlap � � � ! restrictions. EnergyGauge Summii0 Fla/Com-2014.TAM 2014-1.0 Compliant Software.Effective Date:June 30,2015 � Florida Building Code,Fifth Edition(2014)-Energy Conservation IECC 2012-Total Building PerFormance Compliance Option 1/11/2017 � Page 11 of 13 �