Laserfiche WebLink
Q�T3PVINITYJERD <br /> Table s: Roof Cover Options <br /> Asphalt Foam-On Wood Slate or <br /> Underlayment Shingles Nail-On Tile Tile Metal Shakes& Simulated <br /> Shingles Slate <br /> Deck-Armor'" Yes Contact Mfg. No Contact Mfg Contact Mfg Contact Mfg <br /> RoofPrOTM Yes No No No Yes Yes <br /> Shingle-Mate'"" Yes No No No No No <br /> Tiger Paw'" Yes No No No No No <br /> VersaShield@ Yes No No Yes Yes Yes <br /> Liberty—SBS Base/Ply Yes No No No No No <br /> Ruberoid@ SA Base/Ply Yes No No No No No <br /> StormGuard@ Yes No No Yes No No <br /> UnderRoofTm 2 Yes Yes Yes No No Yes <br /> See 5.4.1 <br /> UnderRoof'"HT Yes No No Yes No No <br /> Weather Watch@ Yes No No No No No <br /> Weather Watch@ XT Yes No No No No No <br /> 5.4.1 "Foam-On Tile" is limited to use of Polyfoam PolyPro AH160 unless tensile adhesion / long <br /> term aging data from an accredited testing laboratory is provided. <br /> 5.5 Allowable substrates for LibertyTM SBS Self-Adhering Base/Ply Sheet; Ruberoid@ SA Base/Ply <br /> Sheet; StormGuard@ Leak Barrier; UnderRoof m 2 Leak Barrier; UnderRoofrm HT Leak Barrier; <br /> Weather Watch@ Leak Barrier; and Weather Watch@ XT Leak Barrier are noted below: <br /> 5.5.1 Direct-Bond to Deck: <br /> ➢ New untreated plywood; <br /> ➢ Existing untreated ASTM D41 primed plywood. <br /> 5.5.2 FRSA/TRI 07320 does not address wind uplift resistance of direct-deck, adhered underlayment <br /> systems beneath foam-on tile systems, where the bonded underlayment forms part of the <br /> load-path. The following wind uplift limitations apply to direct-deck, adhered GAF <br /> underlayment systems for use under foam-on tile. <br /> 5.5.2.1 Maximum Desian Pressure = -45 psf. <br /> Deck: Min. 15/32-inch plywood to meet project requirements to satisfaction of AHJ. <br /> Primer: (Optional) ASTM D41 <br /> Underlayment: UnderRooFm 2 Leak Barrier, self-adhered <br /> 5.5.3 Bond to Mechanically Attached Base Underlayment: <br /> ➢ ASTM D226, Type II felt. <br /> ➢ StormSafe@ Anchor Sheet <br /> For installations under mechanically attached prepared roof coverings, base layer shall be <br /> attached per minimum codified requirements. For installations under foam-on tile systems, <br /> base layer shall be attached per minimum requirements of FRSA/TRI 07320/8-05 or RAS 120. <br /> 5.5.4 Bond to Other Substrate Types: <br /> ➢ ASTM D41 primed metal (flashing metal, valley metal, etc.) <br /> I <br /> Exterior Research and Design, LLC. Evaluation Report 01506.04.08-115 <br /> Certificate ofAuthorization#9503 FL10626-R5 <br /> Revision 5: 11/02/2011 <br /> Page 4 of 11 <br />