18-19658 - Laserfiche WebLink

Browse Search

ROCK-IT sJSTem 4.0 inSTaLL c - rp �1 t 9 1 l d 4 Y 1 Pop f Fig.A Install EcoFasten Solar Flashing with,Rock-it Mounts •Fo1IowEao%stenSolarlmt3111nstructlonsforflasldng and bracketinstall(Gi6enFadenshownabove). •Optimum verticald(stancebdweenlag bob IsI3 rplusmoduledimeriskm •Setmorntsoneavemostrowsothaf the lodctPedesWisoniheSm.MendofRock4tsUde •Set mounts on all upper rows sothattheRodkltPedestalison the North e,ndofRock-it Slide- 2 Install Rock It Array Skirt onto Eave Mounts Slide Rock-it Array Skirt into front'channel on Rock-It Shelf. • Array Skirt End Caps are pre-installed on the East end of each skirt section,and are used to couple the skirt sections where needed(see Fig.A). Tighten Mid-Clamp bolt;clamping Rack-lt Array Skirt to mount.Torque to 200 in-lbs.(130In-firs.when instaiitng with 32mm modules). 3-4 Install Rock-It CouPlings(when joining 4 panels with a Coupling,the use of a load bearingioot Is required) • Prior to mounting on the'roof,snap Load Bearing Foot Imo the bottom of Rock It Coupling if required: (Each Load Bearing Foot is set to same height as the Rack-It Mounts-adjust accordingly) •On eave row only,slide Rock-It Array Skirt onto Rock-It Coupling Shelf.Torque to specified value • NOTE:If a coupling lands on a rafter,the Hybrid Mount'should be used in place of the Rock-it Coupling(refer to Image 3a). -Hybrid Mount can be made In the field by assembling a coupling to a mount pedestal,or by purchasing separately. iJ Align and Straighten First ROW of the Rock-it System With Rock-It Array Skirt. •use North-South adjustment of the Rock-ItPedesW.tostraightenRocklt Array Skirt and align module with Array Skim Torque screw on side of Rod-It Pedestal to 150 in-lbs to secure ittothe Rock4tSlide •Adjust Flange Level Nut to level the system(optional-can be leveled during orafter Installation). 6_9 Install 1st Row of PV Modules 56de upsiope Rock-It Mounts down to engage top of first module. •InstallRo*4 Couplingson the upslope side oflstrowofpanels. •Torque 2nd rowof Mid-Clamps on Rock4tMounts and Rode-ItCouplings to specified value. •Install balance of PV modules,eniuring that the Ro&-It Pedestals are In the appropriate po5ition,then torque Mid-Ciampi to secure modules. 10 Level the Rock-It System When assembly is complete,level the entire system by adjusting Flange Level Nuts(Flange Level Nuts have no torque value). • Height between roof surface and underside of modules should be 3'or less,when Installed with Type 2 modules. INSTALLATION NOTE:Modules should be installed so that the Junction box Is Installed upslope,away from the leading edge of the array, ummecofastensolar.com info@ecofastensolarcom 877-859-3947 5