Laserfiche WebLink
Strap Requirements <br /> GALVANIZED STRAPS.60 OUNCES EACH SIDE OR NOMINAL G115 Florida now requires that all strapping have extra galvanization <br /> to protect from the elements.All strapping must be marked with the"G115"coating,and Tie Down strap will indicate"QUAD COAT <br /> G-120." The ASTM 3953-91 must still be referenced on the strap to indicate conformity to the HUD Code,and the 6115 will indicate <br /> the extra coating. All strap must be marked every 12"to 15". <br /> Strap Marking <br /> TIE DOWN ENGINEERING <br /> LE PROTECTION <br /> TIE DOWN ERTHIEENGINEERING CERTIFIED TO <br /> CERTIFlED TO' <br /> ED PRQiECT10N ANSIA220.ASTM D39W91 <br /> ANSI A225.1 ASTM D3953-01 <br /> s ,:} QUAD THICK G-120 <br /> GALVANIZED PROTECTION <br /> Meets Florida 15 C Requirements <br /> Strap Attachment <br /> Strap must be factory attached to the connecting bracket proper Strap Tensioning <br /> Connecting brackets must have a radius clip to protect the <br /> strap from sharp edges.Field attached crimp seals are no <br /> longer allowed for use on strap to attach to frame connec- <br /> tors or hooks. o <br /> 12-15 inches � <br /> Swivel Connector _: cut '1 <br /> O with radius clip. <br /> Part#59002&59242 1.Insert slotted bolt into <br /> with out strap anchor head,attach loosely. 2.Insert the strap end into <br /> =I Pull strap past bolt head the slot in bolt until flush <br /> and cut strap so that 12-15 with opposite side of bolt. <br /> inches of strap are available <br /> to wrap onto the slotted <br /> bolt. <br /> J <br /> Strap Splice :V <br /> Friction splice using a buckle is not <br /> acceptable. To lengthen a factory <br /> made strap in the field, a double 4.Hold the bolt under <br /> crimp seal splice is required. Over- tension while tighten- <br /> lap strap approximately 12 inches 3.Using 15/16"wrench ing the nut, drawing <br /> and use two crimp seals evenly or socket,turn the bolt, the head of the bolt into <br /> spaced. winding the strap so that the recess..After the <br /> a minimum of four to five bolt is within the recess, <br /> complete turns are made, continue to tighten the nut <br /> and the strap is adequately until securely fastened. <br /> 2 Seals— tensioned. <br /> 2 Crimps per seal <br /> TIE m <br /> DOWN ENGINEERING 255 Villanova •rive SW - Atlanta, GA 30336p <br /> n <br />