18-20581 - Laserfiche WebLink

Browse Search

HVAC 6.5.2.4.1 Mechanical Humidifiers with airstream mounted preheating ❑ jackets have preheat auto-shutoff value set to activate when humidification is not required. HVAC 6.5.2.4.2 Mechanical Humidification system dispersion tube hot 1:1 El surfaces in the airstreams of ducts or air-handling units insulated>=R-0.5. SYSTEM—SPECIFIC 6.6.3.2.2 Mechanical VAV fans have static pressure sensors positioned so setpoint<=1.2 in.w.c. design pressure. SYSTEM—SPECIFIC 6.5.4.5.1 Mechanical Two-position automatic valve interlocked to shut off water flow when hydronic heat pump with pumping system>10 hp is off. SYSTEM—SPECIFIC 6.5.6.2 Mechanical Condenser heat recovery system that can heat water to 85 A°F or provide 60%of peak heat rejection is installed for preheating of service hot water. HVAC 6.5.7.1.5 Mechanical Approved field test used to evaluate design air flow rates and demonstrate proper capture and containment of kitchen exhaust systems. SYSTEM—SPECIFIC 6.5.9 Mechanical Hot gas bypass limited to: <=240 kBtu/h W 15% >240 kBtu/h s€"10% HVAC 6.4.3.9 Mechanical Heating for vestibules and air curtains include El El El automatic controls that shut off the heating system when outdoor air temperatures>45F. Vestibule heating systems controlled by a thermostat in the vestibule with setpoint<=60F. Controls 6.5.10 Mechanical Doors separating conditioned space from the El 1:1 El outdoors have controls that disable/reset heating and cooling system when open. Controls 9.4.1.1 Interior Lighting Automatic control requirements prescribed in Table 9.6.1,for the appropriate space type,are installed.Mandatory lighting controls(labeled as 'REQ')and optional choice controls(labeled as 'ADD1'and'ADD2')are implemented. Controls 9.4.1.1 Interior Lighting Independent lighting controls installed per " approved lighting plans and all manual controls readily accessible and visible to occupants. Controls 9.4.1.2 Interior Lighting Parking garage lighting is equipped with required lighting controls and daylight transition zone lighting. Controls 9.4.1.1f Interior Lighting Daylight areas under skylights and roof monitors that have more than 150 W combined input power for general lighting are controlled by photocontrols. Controls 9.4.1.4 Exterior Lighting Automatic lighting controls for exterior lighting El 1:1 ❑ installed. Controls 9.4.1.3 Interior Lighting Separate lighting control devices for specific uses installed per approved lighting plans. Wattage 9.6.2 Interior Lighting Additional interior lighting power allowed for special functions per the approved lighting plans and is automatically controlled and separated from general lighting. Wattage 9.6.4 Interior Lighting Where space LPD requirements are adjusted 0 based on room cavity ratios,dimensions are consistent with approved plans. Insulation 5.5.3.1 Envelope Roof R-value.For some ceiling systems, verification may need to occur during Framing Inspection. Insulation 5.8.1.2,5.8.1.3 Envelope Roof insulation installed per manufacturers€TMs instructions. Blown or poured loose-fill insulation is installed only where the roof slope is<=3 in 12. El El Insulation 5.8.1.1 Envelope Building envelope insulation is labeled with ❑ R-value or insulation certificate has been provided listing R-value and other relevant data. Insulation 6.8.1.9 Envelope - Building envelope insulation extends over the full area of the component at the proposed rated R or U value. Insulation 5.8.1.4 Envelope Eaves are baffled to deflect air to above the insulation. Insulation 5.8.1.5 Envelope Insulation is installed in substantial contact with the inside surface separating conditioned space from unconditional space. EnergyGauge Summit®Fla/Com-2017.TAM 2017-1.0 Compliant Software.Effective Date:Dec 31,2017 Flodda.Building Code,Sixth Edition(2017)-Energy Conservation ASHRAE 90.1-2013-Prescriptive Compliance Option 7/6/2018 Page 13 of 21