19-20704 - Laserfiche WebLink

Browse Search

DONNELLY ENGINEERING ELECTRICAL locations shall be as accepted by the Engineer during construction. Obtain in the field all information relevant to the placing of electrical work and in case of interference with other work, proceed as directed by the Engineer and provide all labor and materials necessary to complete the work in an acceptable manner. B. Discrepancies: Notify Engineer of any discrepancies found during construction of the project and do not proceed with that portion of the project, until a written definitive statement is received providing clear direction. If a conflict exists between the contract documents and any applicable code or standard, the most stringent requirement shall be included for this project. The Engineer shall make the decision regarding questionable areas of conflict. C. Wiring: Each three-phase circuit shall be run in a separate conduit unless otherwise shown on the Drawings. Unless otherwise accepted by the Engineer, conduit shall not be installed exposed unless specifically directed to be exposed. Where circuits are shown as "home-runs" all necessary fittings and boxes shall be provided for a complete raceway installation. Do not install more than three circuits in a single raceway. Circuit numbers indicated for new circuits shall not be changed. Use the circuit numbers indicated. D. Surface Supports: Surface mounted panel boxes, junction boxes, conduit, etc., shall be supported by spacers to provide a clearance between wall and equipment. E. Layout: Circuit layouts are not intended to show the number of fittings, or other installation details. Provide all labor and materials necessary to install and place in satisfactory operation all power, control, lighting, and other electrical systems shown. All connections to equipment shall be made as required, and in accordance with the accepted shop and manufacturer's setting drawings. F. Coordination: Coordinate final equipment locations with existing conditions. Layout before installation so that all equipment has adequate space. Provide coordination as required for installation in a neat and workmanlike manner. 1.5 EQUIPMENT SIZE AND HANDLING A. Coordination: Investigate each space in the structure through which equipment must pass to reach its final location. If necessary, the equipment shall be required to be shipped in sections of specific sizes to permit the passing through the necessary areas within the structure. B. Handling: All equipment shall be kept upright at all times. When equipment has to be tilted for ease of passage through restricted areas during transportation, the manufacturer shall be required to brace the equipment suitably, to insure that the tilting does not impair the functional integrity of the equipment. 1.6 RECORD DRAWINGS A. Production: The Contractor shall provide two (2) sets of black or blue line on white drawings to maintain and submit record "as-built drawings". One set shall be maintained at the site and at all times be accurate, clear, and complete, showing the actual location of all equipment as installed. The Record Drawings shall show actual locations of all underground lines and accurate wiring diagrams of all power, light and other systems marked in colored pencil "As Installed". The underground lines shall be shown "dashed". The "Progress As-Built" drawings shall show all Electrical work installed complete to the present stage of progress, actual routing of all branch wiring, actual routing of homeruns including all junction or pull boxes, drops and risers and the location of all junction boxes and access panels. These drawings shall be available to the Engineer's field representatives at all times. Heartland Health Care Center of Zephyrhills-3181 16010-2 DE No 217032 38220 Henry Drive,Zephyrhills, FL 33542 Pending Emergency Rule 59A-4.1265