19-21503 - Laserfiche WebLink

Browse Search

F. Where Contract Documents conflict, such conflict shall be brought to the attention of the Architect for clarification. In general, the Architectural Drawings shall take precedence over the HVAC Drawings with regard to building construction. Any change from the Drawings necessary to make the work conform to the building as it is constructed, to fit the work of other trades, or to the rules of authorities having jurisdiction, shall be made at no expense to the Owner. G. No interpretation shall be made from the limitations of symbols and diagrams that any elements necessary for complete Work are excluded. H. Certain details appear on the Drawings, which are specific with regard to the dimensioning and positioning of the Work. These details are intended only for the purpose of establishing general feasibility. They do not obviate responsibility for field coordination for the indicated Work. I. Capacities, sizes and conditions specified or shown are allowable minimums. Based on design and rated operating conditions of systems, motors shall not be overloaded. Equipment shall not operate at speeds or temperatures greater than manufacturer's published recommendations, and no strain or demand shall be imposed upon any component to any system, structure or building. J. The Engineer reserves the right to make minor changes in the location of HVAC work or equipment prior to "roughing-in" without additional cost to the contract. Engineer approval for deviations from drawing locations and layout shall be obtained prior to installation. K. The use of a word in the singular shall not be considered as limiting where other indications denote that more than one item is required. L. In the event that extra work is authorized, work shown on Drawings depicting such work, and/or described by Addendum, Architectural Supplemental Instruction, or by Change Order, shall be subject to the basic requirements set forth in Division One and Contract Documents in all respects. 1.6 QUALIFICATIONS A. All entities and personnel performing work for this project shall be regularly engaged and experienced in the type of work to be furnished and shall be licensed for such specialty trades, employ only properly qualified foremen, journeymen and apprentices as appropriate and in keeping with best trade practices. B. Each firm shall provide, upon request, a list of similar jobs it has completed. 1.7 CONSTRUCTION REQUIREMENTS A. Locations of all pipes, ducts, panels, appliances, etc., as shown on the Drawings are approximate only and are understood to be subject to such revisions as may prove necessary or desirable at the time the work is installed. All work shall be installed with relation to building conditions and shall be installed correct with reference to finished elevations, etc. Exterior utilities shown on the drawings are diagrammatic only. Their exact locations, depths and invert elevations shall be as required for proper flow and coordination with other trades. B. The Drawings show the general arrangement of piping and ductwork. Should local conditions necessitate any rearrangement, and before proceeding with the work, prepare and submit five (5) copies of Drawings of the proposed arrangement for the Architect's review. C. If equipment, piping, and ductwork, are installed requiring space conditions other than those shown, or arranged, and rearrangement of the space is necessitated, the Engineer shall review CEA#18010 HEATING,VENTILATING AND AIR CONDITIONING (HVAC) 23 00 00-3 COPYRIGHT©2018 CONSULTING ENGINEERING ASSOCIATES, INC.