19-21503 - Laserfiche WebLink

Browse Search

L. All products with compressor sections shall be started by a factory trained service technician. Provide written report indicating start-up results. Provide extended compressor parts warranty for all compressors for a total five year warranty on all compressors. Provide manufacturer's phase loss protection. 3.2 SHOP DRAWINGS AND SUBMITTALS A. The Engineer shall have the authority to determine the method of submitting shop drawings whether in multiple sets or by the reproducible transparency technique. B. Submittals are required for all items of mechanical equipment and products. C. For items reviewed and marked "Rejected" or "Revise and Resubmit", only one additional submittal will be reviewed to verify product compliance with the Contract Documents. Should further submittals be required for the Design Professional to verify the submittal with the requirements of the Contract Documents, the hourly rate of $ 150.00 will be billed to the Contractor for the Professional(s)time spent on the review. D. Submittals shall be referenced to the Contract Documents. For all equipment, which has been scheduled directly on the Drawings, provide within the submittal, a performance schedule for the proposed equipment in the same format as included on the Contract Documents. E. Manufacturer's catalog cuts may be submitted for all standard cataloged equipment, provided that the item required to meet the project specification is not modified in any way from the standard catalog version. Where multiple products are included on the same cut sheet, clearly identify the product proposed for installation by striking through all sections not applicable to the proposed product. Do not provide useless or unnecessary pages in the submittal package. F. Cut sheets shall be clearly marked to indicate the exact size, type, rating, capacity, etc., of the item to be provided. G. Bind shop drawings/catalog-cuts in three ring binders with a title sheet and identification on front and side of the binder. Allow space for Contractor, Project Architect and Engineer review stamps. Index all items to the Project Manual or Drawings as applicable. H. All submittals must bear the handwritten signature of the Contractor and his stamp of approval before being considered for review by the Engineer. I. Full electrical characteristics for each device requiring power shall be prominently displayed on the shop drawings or submittal. Additionally, a statement signed by maker of the submittal shall be included indicating that he or she has carefully examined the electrical characteristics specified in the Contract Documents (and if remodeling or an addition, as to existing electrical characteristics), and that the motors, equipment or devices proposed to be furnished are fully compatible. A similar statement shall be included stating the supplier has reviewed the space requirements of the project and that the submitted equipment will fit in the space provided and the manufacturer's required service requirements have been met. J. Shop drawings that deviate from the requirements of the contract documents shall list all differences in a cover letter attached to top of the submittal. 3.3 EXAMINATION OF EXISTING CONDITIONS CEA#18010 HEATING,VENTILATING AND AIR CONDITIONING (HVAC) 23 00 00-6 COPYRIGHT©2018 CONSULTING ENGINEERING ASSOCIATES, INC.