19-22071 - Laserfiche WebLink

Browse Search

ROCK-IT SJ-STeI'1"1 4,0 inSTaLL ON 7. PWA a ' 1 � J ' 1 Fig.A Install EcoFasten.Solar Flashing with Rock-It.Mounts •Follow EcoFastanSolminstalllnstructionsforflashing and bradrethntall(GreenFasten shown above). •Optimum vertical dlstancebetween lag bolts is13Wplus module dimension. •Set mounts on eave most row sothat the Rock-It Pedestal is on the South end of Rock-It Slide. •-Set mounts on all upper rows so that the Rock:lt Pedestal Is on the North end of Rode-R Slide 2 Install Rock-It Array Skirt onto Eave Mounts • Slide Rock-It Array Skirt Into front channel on Rock-It Shelf. • Array Skirt End Caps are pre-installed on the East end of each skirt section,and are used to couple the skirt sections where needed(see Fig.A). •Tighten Mid-Clamp bolt,clamping Rock-It Array Skirt to mount:Torque to 2001n4bs.(130 in-Ibs.when installing with 32mm modules). 3_4 Install Rock-It Couplings(when joining 4 panels with a Coupling,the use of a load bearing foot Is required) • Prlor'to mounting on the roof,snap Load Bearing Foot into the bottom of Rock-It Coupling If required. (Each Load Bearing Foot is set to same height as the Rock-It Mounts-adjust accoidingly) •.On.eave rowonly,slide Rock-It Array Skirt onto Rock-It coupling Shelf.Torque to specified value. • NOTE:If a coupling lands on a rafter,the Hybrid Mount'should be used in place of the Rock-It coupling(refer to image 3a): 'Hybrid Mount can be made in the field by assembling a coupling to a mount pedestal;or by purchasing separately. 5Align and Straighten"First Row of.the"Rock-It System with Rock-It Array Skirt •UseNorth-&uth adjustment oftheRock-it Pedestal to straighten Rock-It Array Skirt and align module with Array SkIrL •Torque screw on side of Rock-It Pedestal to 150ln4bs to secure it to the Rock-It slide. Adjust Flange Level Nut to level the system(optional—can be leveled during or after installation). 6-9 Install 1st Row of PV Modules. •Slide upslopeRock-t Mounts down to engage top offirstmodule. •Install Rock=lteoupltngson the upsiopesideoflst row ofpanels. •Toque 2nd row of MidClamps on Rock-It Mounts and Rock-It couplings to specified value. •Install balance ofPV modules,ensuring thatthe Rodc4t Pedestals aye In the appropriate position,then torque Mid-Camps to secure modules. " 10 Level the Rock-It System •When assembly Is complete,level the entire system by adjusting Flange Level Nuts(Flange Level Nuts have no torque value). • Height between roof surface and underside of modules should be 3'orless,when Installed with Type 2 modules. INSTALLATION NOTE:Modules should.be installed so that the-Junction box Is installed upslope,away.from the leading edge of the array. www.ecofastensolarcom info@ecofastensolarcom 877-859-3947 5