Laserfiche WebLink
/ I <br /> Installation Dimensions and Cover Plate Information 51-'@1 ra <br /> Min.to Max. <br /> Recommended Min.to Max. Dropped Cover Plate <br /> Cover Plate Cover Plate Face of Fitting <br /> Hole Diameter Deflector Temperature <br /> Cover Plate Diameter I Adjustment to <br /> in Ceiling Distance Rating <br /> Model Inch Inch Inch Ceiling(') below Ceiling °F <br /> (mm) (mm) (mm) Inch Inch C <br /> (mm) (� ) <br /> (mm) <br /> G4/G5 3-5/16 <br /> (84) 135°F(3) <br /> G4/G5 QR 3-11/16 (57°C) <br /> Gasket(') (94) 2-5/8 3/4 1-1/2 to 2-1/4 1/4 to 1 <br /> (67) (19) (38 to 57) (6 to 25) or <br /> G4/G5 SR 4 165°F(4) <br /> Gasket(2) (101 mm) (74°C) <br /> Notes: <br /> 1. Face of fitting to ceiling dimensions are based on1nominal thread make up. Verify dimensions based on fitting and thread sealing <br /> method prior to installation.A 1/2"x 1/2" brass nipple extension (Reliable P/N 6999991900)is available to assist with replacement of <br /> Reliable Model G4A sprinklers. <br /> 2. Model G4/G5 QR Gasket and Model G4/G5 SR Gasket cover plates are sold as assembled units including both the cover plate and <br /> gasket.Model G4/G5 QR Gasket and Model G4/G6 SR Gasket cover plates and gaskets are not interchangeable. <br /> 3. For use with 1650F(74°C)temperature rated sprinklers where the Maximum Ceiling Temperature does not exceed 100°F(38°C). <br /> 4. For use with 212°F(100°C)temperature rated sprinklers where the Maximum Ceiling Temperature does not exceed.150°F(660C). <br /> I Cover Plate Finishes('( -• - <br /> Standard Finishes Special Application Finishes Listing &Approval Agencies <br /> White Paint Off-white Paint Individual Model G5 series sprinkler may be listed or ap- <br /> Chrome Black Paint proved by the following agencies: <br /> Custom Color Paint-Specify(2) Underwriters Laboratories, Inc. and UL Canada(cULus) <br /> Raw Brass(Lacquered) Listing Category: Sprinklers,Automatic and Open <br /> Bright Brass Guide Number:VNIV <br /> Finished Bronze <br /> Black Plated FM Approvals(FM) <br /> Satin Chrome Loss Prevention Certification Board(LPCB) <br /> Stainless Steel Clad(3) VdS Schadenverhutung GmbH (VdS) <br /> Notes: EC-Certificate of Conformity 0832-CPD-2062(CE) <br /> 1. Paint or any other coating applied over the factory finish will,void See Table A and the individual sprinkler data sheets in this <br /> all approvals and warranties.Gaskets for Model G5 QR Gasket Bulletin for listings and approvals applicable to each sprinkler. <br /> and Model G4/G5 SR Gasket cover plates are only available in <br /> white. <br /> 2. Custom color paint is semi-gloss unless specified otherwise! Installation <br /> 3. Stainless steel clad cover plates are Type 316 Stainless Steel Model G5 series sprinklers are intended to be installed <br /> on the finished side and C102 Copper Alloy on the back side. in accordance with NFPA 13, FM Global Property Loss <br /> Cover plates are not listed or approved as corrosion resistant. Prevention Data Sheets,and the requirements of applicable <br /> authorities having jurisdiction. Model G5 series sprinklers <br /> Application ! must not be installed in ceilings with positive pressure in the <br /> Model G5 series sprinklers are standard coverage,flat plate space above. Ensure that the 4 slots in the cup are open and <br /> unobstructed following installation, <br /> _ concealed pendent sprinklers.The sprinklers are intended for <br /> use in accordance with NFPA 13 and FM Global Property Loss Model G5 series sprinklers are shipped with a wrench-able <br /> Prevention Data Sheets,as well as the requirements of the protective cap that should remain on the sprinkler until the <br /> applicable approval agencies. sprinkler system is placed in service following construction. <br /> Model G5 series sprinklers can be installed without removing <br /> Model G5 series sprinklers are available as either Quick- the wrench-able protective cap using the Model W3 wrench. <br /> response(QR)or Standard-response(SR)depending on the Alternatively, Model G5 series sprinklers can be installed <br /> approval agency and cover plate selected. I using the Model FC wrench by temporarily removing the <br /> protective cap during installation of the sprinkler.The use of <br /> any other wrench to installed Model G5 series sprinklers is not <br /> Model G5 series sprinklers use Model G4/G5 flat cover plates. permitted and may damage the sprinkler. <br /> Model G4/G5 QR Gasket and G4/G5 SR Gasket cover plates <br /> are available to limit air and dust movement through the <br /> ceiling. <br /> Bulletin 034 Page 8 of 9 <br /> January 2020 Rem www.reliablesprinkler.com <br /> I <br />