20-90 - Laserfiche WebLink

Browse Search

L ROCK-IT SYSTeI.1`1 4.0 I nSTa LL l k a 5 f4 I R&A 1 install Ectilcasten Solar Flashing with Rock-it.Mounts Follow EcoFasten solarinstall lrutruMors forflashing and brackethutail(GreenFasten shaven above). •Optimum vertical distance between tag bolts is 13/8'plus module dimension. •Set mounts on eve mostrowsothattheRodc-k Pedestal Isonthe5outhendofRock4tSilde. •Set mounts on all upper rows sothat the Rock:it Pedestal Ison the No"end ofRock4tSlide. 2 Install Rock-It Array Skirt onto Eave Mounts • Slide Rock-It Array Skirt into front channel on Rock-It Shelf. -.Array Skirt End Caps are pre-lmtalied on the East end of each skirt section,and are-used to-couple the skirt sections where needed(see Fig.A). Tighten Mid-Clamp bolt,clamping Rock-It Array Skirtto mount.Torque to 200 hrtbs.(130In-tbs.when installing with 32mm modules). _4 Install Rock-It Couplings(when Joining 4 panels with a Coupling,the use of,a load bearing foot Is.required) • Prior to mounting on the roof,snap Load Searing Foot into the bottom of Rock-It Coupling if required.. (Each Load Bearing Foot Is set to same height as the Rock-It Mounts,-adjust accordingly)- •.On eave row only,slide Rock=lt Array Skirt onto Rock-It Coupling Shelf.Torque to specified value. • NOTE:If a coupling lands on a rafter,the Hybrid Mounts should be used In place of theRock-It Coupling(refer to imageAa)', *Hybrid Mount can be made in the field by assembling a coupling to amount pedestal;or-by purchasing separately. C, Align and Straighten First Row of the Rock-it System with Rock-it Array Skirt •Use North-South adjustment of the Rock-It Pedestal to straighten RodWtArray Skirt and align module with Array Skirt •Torque screw on side ofRock-It Pedestal to150in-Ibsto secure itto the Rdck-ItSlide. Adjust Flange Level Nut to level the system(optional—ran be leveled during or after Installation). 6_9 install 1st Row of PV Modules •Slide upslapeRock-It Mounts down to engage top offirst module. •install RockttCoupiingson the upstope side ofIst row ofpanels. •Torque 2nd row of Mid{lamps an Rock-it Mounts and Rock=tt Couplings to specified value. •Install balance ofPV modules,ensuring thattheRodc-It Pedestals are In the appropriate position,then torque Mid-Camps to secure modules. 1.0 -Level the Rock-It System •When assembly Is complete,level the entilmsystem by adjusting Flange Level Nuts(Flange Level Nuts have no torque value): •Height between roof surface and underside of modules should be 3'or less,when Installed with Type 2 modules INSTALLATION NOTE:Modules should be'installed so that the junction box Is Installed upslope,away.fram theleading-edge of the array. wwwecofastensolarcom info@ecofastensolarcom 877=859-3947 5