20-181 - Laserfiche WebLink

Browse Search

ROCK IT SY,STeI'l`1 4.0 insTaLL •..*•f'.i. III � 1C' III III I - I R 1 Fig.A install EcoFasten solar Flashing with Rack-It.Mounts •FollowEcolastenSolarinstalllnsWctloniforflashingandbracketIstall(GreenFastenshownabove).- •optimum vertical distancebetween tag bolts Is 1 3Arplus module dimension. •SetountsoneavemostmwsothattheRodcatPedestalisontheSouthendofRock-RSRds • mSet mounts on allupper mwsso thattheRod0tPedlestal'Is on the North end of Rod(4t SH& 2 Install Rock-It Array Skirt onto Eatre Mounts • Slide Rock-It Array Skirt into front channel on Rock It Shelf. •Array Skirt Enid Caps are pre-Installed on the East end of each skirt sectlon,and are used to couple the skirt sections where needed(see Fig.A). Tighten Mid-Clamp bolt,clamping Rocklt Array Skirt-to mount.Torque to 200 dribs.(130 in-lbs,when Installing with 32mm modules). —q- Install Rock-it Couplings(when joining 4 panels with a Couplingrthe use of a load bearing foot Is,required) • Prior to mounting on the roof,snap Load Bearing Foot Into the bottom of.Rodc-It Coupling If required. (Each Load Bearing Foot is set to same height as the Rock-it Mounts-adjust accordingly) • On eave row only,slide Rockit Array Skirt onto Rock It Coupling Shelf.Torque to specified value. • NOTE:If a coupling lands-on a rafter,the Hybrid Mount'should be used in place of the'Rock-It Coupling(refer to image:3a). "Hybrid Mount can be made in the field by assembling a coupling to a mount pedestal,or by purchasing separately, C, Align and Straighten First Row of the Rock-it System with Rock-it Array.Skirt •Use North-South adjustment of the Rock4t Pedestal to straighten Ro&4t Array SkIrt and align module with Array SklrL •Torque screw on side of Rock-it Pedestal toISoin-ibstosecureitto the Rock-ItSlide. -Adjust Flange Level Nut tolevel the system(optional—can be leveled daringoraRerkutatlatlim)• 6-7 Install 1st Row of PV Modules •Slide upslope Rode-It Mounts down to engage top of first modulo— Install Rock-ItCouplIngs on the upsiope side ofist raw ofpanels. -Tonlue2nd row ofMid:ClampsonRock-It Mounts and Rock-it Couplings to specified value. •Install balance of PV modufesensudng that the Rock-ft Ped.estali are in the appropriate position,then torque MId-Clamps to secure moddes. 10 Level the Rock-it System •when assembly Is complete,level the entire system by adjusting Flange Level Nuts(Flange Level Nuts have no torque value). • Height between roof surface and underside of modules should be 3"or less,when Installed with iWw 2 modules INSTALLATION NOTE:Modules should.be Installed so that theJunctlon box is installed upslope,•away.from the-leading edge of the array. www.ecofastensolar.com iiifo@ecofastensoiarcom 877-859-3947 -5