20-513 - Laserfiche WebLink

Browse Search

T 467 Swan Ave • Hohenwald,TN 38462 • (800) 284-7437 • www.olivertechnologies.corn • Fax (931) 796-8811 INSTALLATION USING CONCRETE RUNNER/FOOTER 15. A concrete runner,footer or slab may be used in place of the steel ground pan. a) The concrete shall be minimum 2500 psi mix b) A concrete runner may be either longitudinal or transverse,and must be a minimum of 8"deep with a minimum width of 16 inches longitudinally or 18 inches transverse to allow proper distance between the concrete bolt and the edge of the concrete(see below). c) Footers must have minimum surface area of 441 sq.in.(i.e.21"square),and must be a minimum of 8"deep. d) If a full slab is used,the depth must be a 4"minimum. Special inspection of the system bracket installation is not required.Footers must allow for at least 4"from the concrete bolt to the edge of the concrete. NOTE:The bottom of all footings,pads,slabs and runners must be per local jurisdiction. LONGITUDINAL:(Model 1101 LC"V"1 16. When using Part#1101-W CPCA(wetset)simply install the bracket In runner/footer OR When installing in cured concrete use Part# 101-D-CPCA(dryset).The 1101 (dryset)CA bracket is attached to the concrete using(2)5/8"x3"concrete wedge bolts(Simpson part# S162300H 5/8"X 3"or Powers equivalent).Place the CA bracket in desired location.Mark bolt hole locations,then using a 5/8"diameter masonry bit,drill a hole to a minimum depth of 3".Make sure all dust and concrete is blown out of the holes.Place wedge bolts into drilled holes,then place 1101 (dry set)CA bracket onto wedge bolts and start wedge bolt nuts.Take a hammer and lightly drive the wedge bolts down by hitting the nut(making sure not to hit the top of threads on bolt).The sleeve of concrete wedge bolt needs to be at or below the top of concrete.Complete by tightening nuts. LATERAL:(Model 1101 TC"V") 17. For wet set(part#1101-W TACA)installation simply install the anchor bolt into runner/footer.For dry set Installation(part#1101-D-TACA) mark bolt hole locations,then using a 5/8"diam.masonry bit.drill a hole to a minimum depth of 3".Make sure all dust and concrete is blown out of the hole.Place wedge bolts(Simpson part#S162300H 5/8"X 3"or Powers equivalent)into(D)concrete dry transverse connector and Into drilled hole.If needed,take a hammer and lightly drive the wedge bolts down by hitting the nut(making sure not to hit the top of threads on bolt),then remove the nut.The sleeve of concrete wedge bolt needs to be at or below the top of concrete. 18. When using part#1101 CVW(wetset)or 1101 CVD(dryset),install per steps 17&18. Notes: 1.LENGTH OF HOUSE IS THE ACTUAL BOX SIZE 2.[�=LOCATION OF TRANSVERSE BRACING ONLY 3 K1 =LOCATION OF LONGITUDINAL BRACING ONLY 4.93—=TRANSVERSE AND LONGITUDINAL LOCATIONS ALL WIDTHS AND LENGTHS UP TO 52' Ell 11 111 ALL WIDTHS AND LENGTHS OVER 52'TO 80" HOMES WITH 5/12 ROOF PITCH REQUIRE:PER FLORIDA REGULATIONS 6 systems for home lengths up to 52'and 8 systems for homes over 52'and up 80'. PATENT#6634150&OTHER PATENT PENDING Page Revision 08/23/18