Laserfiche WebLink
<br /> <br />~ <br /> <br />.. <br /> <br />- <br /> <br />.. <br /> <br />.. <br /> <br />Figure 11. <br /> <br />~o <br /> <br />Figure 11. REFLECTOR PARTS <br /> <br />PART # <br />17 <br />18 <br /> <br />DESCRIPTION <br />Feed Support Rods (4) <br />Reflector Panels (4), <br />[STI-12 (8), XI-7 Plus II (8), STI-16 I (16)] <br />Center Hub Plates (2) <br /> <br />19 <br /> <br /> <br />INST ALLING TI{ [ABLE [LIP <br />_ CABlE PLACE THE CURVED END Of THE CliP <br />OVER THE SECTION JOINING BOLT <br />BETWEEN THE REfLECTOR RIB AND <br />; THE fLAT WASHER BEfORE <br />~' _CABlE TIGHTENING BOLT DURIMiASSEMBLY, <br />V CLIP SPRING THE SHORT SIDE Of THE CLIP <br />TO INSERT THE CABLE. <br /> <br />12 Foot - 8 Section Reflector <br />Focal length: 59" <br />~ <br />@ <br /> <br />NOTE: When the optional high wind support trussing is <br />used: Do not install the second bolt from the outside until <br />the mount is on the reflector face, <br /> <br />2" BOLT <br />"------------;."1.1111. ~ <br />""- <br />-" --"~~~' ~ <br />-.... ..:; :...:- ;111 11& 11111111111111 <br /> <br />.' -- '2'/" BOLT FULL THREAD <br /> <br /> <br />The center plate is designed to center over the center hole <br />in the reflector with the carriage bolts passing through the <br />center hole of the reflector, <br /> <br />When assembly is complete on both halves, lay face down <br />and join halves together to complete reflector assembly. <br />NOTE: ALL FASTENERS SHOULD BE FINGER TIGHT ONLY. <br />WRENCH TIGHTEN ALL FASTENERS ONLY AFTER THE <br />HALVES ARE JOINED TOGETHER. <br /> <br /> <br />"12 "x '/....20 BOLT <br />__ __" p' ,,~"--g'I'hl'l g <br /> <br />FEED SUPPORT (4),-.------.\ <br /> <br /> <br /> <br />DOUBLE RIB (SECTIONAL JOINT) <br /> <br /> <br />_ . OUTER-MOST <br />. ,. INTERMEDIATE SUPPORT <br />'~ ." <br />\~~ <br /> <br />,. <br /> <br />BOLT SLOTTED <br />END TO FEED <br /> <br /> <br />\~9PTIONAL HIGH WIND <br />~PORT T,,"55 <br /> <br /> <br />32" RING .,~ FITS OVER 4'12' <br />'~ 0.0. POLE <br /> <br />After antenna face bolts are tightened, place mount on <br />reflector. Then install 2112" full thread bolt through mount <br />saddle brackets. Now install optional high wind support <br />trusses. <br /> <br />NOTE: When placing the mount on the reflector. DO NOT <br />wrench tighten until all fasteners are in place finger tight. <br /> <br />6 <br />