95-4865 - Laserfiche WebLink

Browse Search

*~ INFILTRATION REDUCTION PRACTICE COt1PlIANCE CHECKLIST ** ==================~====;======================================================== :OMPQNENTS SECTION REQUIREMENTS FOR EACH PRACTICE CHECK ================================================================================ )RACTICE 1:t1 606.1 COMPLY WITH All INFILTRATION PRESCRIPTIVES. -------------------------------------------------------------------------------- ~ i ndows 606.1 Maximum of 0.34 CFM per linear foot of operable sash crack (includes sliding glass doors). ------------------------------------------------------------------------------- ~xter ior & ~djacent Doors 606.1 Maximum of 0.5 CFM per sq. ft. of door area: solid core, wood panel,insulated or glass doors only. ~---------------------------------------------------------------~--------------- ~xter ior Joi nts ;., Cracks 606.1 To be caulked, gasketed, weather-stripped or other- wise sealed. ------------------------------------------------------------------------------- )RACTICE #2 606.1 COMPLY WITH PRACTICE #1 AND THE FOllOWING: ------------------------------------------------------------------------------- :xter ior Walls , Floors 606.1 Top plate penetrations sealed. Infiltration barrier installed. Sole plate/floor joint caulked or sealed. ------------------------------------------------------------------------------- :xterior Walls , Ceilings 606.1 Penetrations, joints and cracks on interior surface caulked, sealed or gasketed. ------------------------------------------------------------------------------- luctWor k 606.1 Ductwork in unconditioned space must be sealed. ------------------------------------------------------------------------------- . i replaces 606.1 Equipped with outside combustion air, doors and flue dampers. .------------------------------------------------------------------------------ xhaust Fans 606.1 Equipped with dampers. Combustion devices see 606.1.A.2. -------------------------------------------------------------------------------- ombustion Ippl ia nces 606.1 Be in unconditioned space (except direct vent), draw air from unconditioned space, exhaust to outside. Cooking appliances shall be dampered and use intermittent ignition. ----------------~--------------------------------~----------------------------- ater Heaters * OTHER PRESCRIPTIVE MEASURES (must be met or exceeded by all residences.) ** ------------------------------------------------~~----------------------------- 612.1 Comply with efficiency requirements in Table 6-12. Switch or clearly marked circuit breaker (electric) or cutoff (gas) must be provided. External or built- in heat trap required. wimming Pools Spas ------------------------------------------------------------------------------- 612.1 Spas and heated pools must have covers (except solar heated). Non-commercial pools must have a pump timer. Gas spa & pool heaters must have a minimum thermal efficiency of 78 percent. hower Heads ------------------------------------------------------------------------------ 612.1 Water flow must be restricted to no more than 3 gal- lons per minute at 80 PSIG. --~--------------------------------------------------------------------------- VAC Duct onstruction nsu.lation & nstallation 610.1 All ducts, fittings, mechanical equipment and plenum chambers shall be mechanically attached, sealed, ins- ulated and installed i~ accordance with the criteria of Section 610.1.ABC.2 & 610.1.ABC.3. Du.ct in attics must be insulated to a minimum of R-6. Air handlers shall not be installed in attics unless in mechanical closet. ------------------------------------------------------------------------------ >lAC Controls 607.1 ------------------------------------------------------------------------------ Separate readily accessible manual or automatic thermostat for each system. nsulation 604.1 602.1 Ceilings minimum R-19. Common Walls - Frame R-11 or CBS R-3 both sides. Common ceiling & floors R-11.