|
<br />.-
<br />
<br />FLORIDA ENERGY EFFICIENCY CODE FOR BUILDING CONSTRUCTION
<br />
<br />FORM 600B-97 Residential Component Prescriptive Method B CENTRAL 4 5 6
<br />Department of Community Affairs
<br />
<br />Compliance with Method 8 Chapter 6 of the Florida Energy Efficiency Code may be demonstrated by the use of Fonn 6008-97 for single and multifamily residences of 3 stories or less in height, and
<br />add~ions to existing residential buildings. To comply, a building must meet or exceed all of the energy efficiency prescriptives in any ~ of the prescriptive component packages 2m! comply with the
<br />prescriptive measures listed in Table 68-1 of this fann. An alternative method is provided for additions of 600 square feet or less by use of Fonn 60OC-97.lf a building does not comply with this method,
<br />it ma still compl under other sections in Chapter 6 of the Code.
<br />
<br />
<br />BUILDER: NE/.
<br />PERMITTING e/7 Y' D F CLIMATE II ~ D
<br />OFFICE: Z ,EP/lt;/?III '--J... S ZONE: 4105 U 6
<br />PERMITNO.~ JURISDlCTlONNO.: ~
<br />
<br />OWNER: !hc- / EY '6.1). J)OiU0
<br />
<br />GENERAL DIRECTIONS
<br />1, New construction including additions which incorporates any of the following features cannot comply using this method: steel stud walls, single assembly roof/ceiling
<br />construction, or skylights or other non-vertical roof glass.
<br />2. Choose one of the component packages "A" through uP' from Table 6B-1 by which you intend to comply with the Code. Circle the column of the package you have chosen.
<br />3. Fill in all the applicable spaces of the "To Be Installed" column on Table 6B-1 with the information requested. All "To Be Installed" values must be equal to or more efficient
<br />than the required levels.
<br />4. Complete page 1 based on the "To Be Installed" column information.
<br />5. Read "Minimum Requirements for All Packages", Table 6B-2 and check each box to indicate your intent to comply with all applicable items.
<br />6. Read, sign and date the "Prepared By" certification statement at the bottom of page 1. The owner or owner's agent must also sign and date the form.
<br />
<br />Please Print
<br />
<br />1. Compliance package chosen (A-F)
<br />2, New construction or addition
<br />3, Single family detached or Multifamily attached
<br />4. If Multifamily-No. of units covered by this submission
<br />5. Is this a worst case? (yes / no)
<br />6. Conditioned floor area (sq. ft.)
<br />7. Predominant eave overhang (ft.)
<br />S, Glass type and area:
<br />a. Clear glass
<br />b. Tint, film or solar screen
<br />9. Percentage of glass to floor area
<br />10. Floor type, area or perimeter, and insulation:
<br />a. Slab-on-grade (R-value)
<br />b. Wood, raised (R-value)
<br />c_ Wood, common (R-value)
<br />d. Concrete, raised (R-value)
<br />e. Concrete, common (R-value)
<br />11. Wall type, area and insulation:
<br />a. Exterior: 1. Masonry (Insulation R-value)
<br />2. Wood frame (Insulation R-value)
<br />b_ Adjacent: 1. Masonry (Insulation R-value)
<br />2. Wood frame (Insulation R-value)
<br />12. Ceiling type, area and insulation:
<br />a. Under attic (Insulation R-value)
<br />b. Single assembly (Insulation R-value)
<br />13. Air Distribution System: Duct insulation, location
<br />14. Cooling system
<br />(Types: central, room unit, package terminal A.C., gas. none)
<br />
<br />15. Heating system:
<br />(Types: heat pump, elec. strip, nat. gas, L.P_ gas, gas h.p., room or PTAC, none)
<br />
<br />16. Hot water system:
<br />(Types: elec., nat. gas, L.P. gas, solar, heat rec., ded. heat pump, other, none)
<br />
<br />
<br />1,
<br />2.
<br />3,
<br />4.
<br />5,
<br />6.
<br />7.
<br />
<br />75
<br />)I (.-0
<br />5 "IV 6 { I
<br />
<br />CK
<br />
<br />OWNER AGENT:
<br />
<br />specifications COV~bY th~ calculation are in compliance w~the
<br />
<br />~ DATE: 6-/~7
<br />designed. is in compliance w~h the Florida Energy Code.
<br />DATE:
<br />
<br />
<br />_1
<br />
<br />"91,,
<br />.t
<br />Single Pane
<br />sq. ft.
<br />sq. ft_
<br />".~ %
<br />
<br />Sa.
<br />Sb.
<br />9,
<br />
<br />Double Pane
<br />sq. ft.
<br />/97. 2..-sq. ft.
<br />
<br />10a. R= @ /'iY lin. ft_
<br /> .
<br />10b. R= sq. ft_
<br />10c. R= sq. ft.
<br />10d. R= sq. ft.
<br />10e. R= sq. ft.
<br />11 a-1 R= sq. ft.
<br />11a-2 R= 1 , /DCp I sq. ft.
<br />11b-1 R= sq. ft.
<br />11b-2 R= I l /)7 sq. ft.
<br />12a. R= 10 " 7 '} sq. ft.
<br />12b. R= sq. ft.
<br />13, R= h i..) A.JC~.A "
<br />14a. Type: C R^ 'I v. do I
<br />14b, SEERlEER: i(!) ( to
<br />14c, Capacity: i 6 )'-00
<br />15a, Type: Ii- 7'
<br />15b. HSPF/COP/AFUE: I' ^- C>
<br />15c, Capacity: 4- J.. () 0 0
<br />16a. Type: C e~t It' q. I
<br />16b, EF: ,q I
<br />
<br />DATE:
<br />
|