Laserfiche WebLink
<br />" <br /> <br />ASSEMBLY (Cont'd) <br /> <br />GENERAL <br /> <br />, <br /> <br />I. <br /> <br />After detennining the size and type of your booth to be employed. ensure that an <br />assembly site is available that meetS the following qualifications: <br /> <br />A. A minimum ofthrce feet at sides of the booth must be clear and free from storage <br />of combustible construction or other operations, A minimum Qfthrec: feet clearance <br />is required in front of the booth opening. with si."( feet or more from the nearest wall <br />preferred from the standpoint of providing smoother air flow through the booth. <br /> <br />8, The floor surface of the booth and operator's working area must be non-combustibie <br />material such as to facilitate the safe cleaning and removal ofresiducs. It must be <br />able to suppOrt dlC: weight aCme booth and the operator. <br /> <br />C. The floor surface of the booth must be flat and level to avoid erection problems 10 <br />alignmem of panels, etC. Shims should be used if necessary. <br /> <br />2. Using chalk, mark the dimensional outline of the booth on the floor, Check ceiling <br />height for ample clearance, Check exhaust outlet location with the roof or wall to avoid <br />obstructions in the line of the e."<hau5t pipe. <br /> <br />3. Unpadc all componentS and stack all pans of the same size together. Each component IS <br />identifiable by a size description listed on view drawing. <br /> <br />4. Using the size description an drawings. ensure that aU spray booth components are at <br />nand. <br /> <br />5. Study all the dl'awings and instructions thoroughly before beginning assembly. Each <br />component i:5 shown by part letter or number on the assembly drawings. This will aid in <br />determining where the variOUs components are to be installed during assembly. <br /> <br />6. Assemble the booth using the assembly drawing. (Always start with the exhauSI chamber <br />section,) <br /> <br />7. Mount exhaust unit and motOr. Exhaust Unit - ensure that there are no obstructions in <br />the unit thaI would dama2e it. Make cenain that electrical connections have been made <br />properly and that direction of rotation is as indicated. Start exhaust Wlit, <br /> <br />8. Install exhaust piping, Where oore than 25' of piping is required. the static pressure is <br />increased in that air flow may be hindered when using the standard exhaust unit <br />recommended for use with the booth. \\'here a piping arrangement of an unusual nature <br />is employed or where two or more elbows are used, a similar condition my exit. <br />Therefore, if either of these situations arise, contact your local disaibutor or the <br />manufacturer for correct recommendations. <br /> <br />9. Instaillighting fixtures, <br />