Laserfiche WebLink
<br />2 SETTING AND FASTENING THE WINDOW <br /> <br />1WO OR MORE PEOPLE.MAY BE REQUIRED FOR THE FOLWWING STEPs. <br /> <br />A. From the exterior, place the window into the opening. Hold the window to the top <br />of the opening to minimize smearing the sealant beads at the sill. Center the window in <br />the opening. <br /> <br />B. Plumb and square the window in the opening. While the exterior flange is being <br />pressed tightly to the opening. starting at the top of each jamb, insert shims between <br />the window jambs and the 1 x 4 at the jambs at each pre-drilled installation hole, making <br />sure the window is plumb and square. If shims are needed at the sill to level the window, <br />shim at the corner of the window, then place additional shims not more than IS" apart <br />on center. <br />Not~: 'There should be DO more than 114" ckarance betwt!en th~ window <br />jamb and opBJing at any point along the sicks of the window, and no more <br />than 118" dearance be~n th~ sill and th~ bottom ofth~ opBJing. <br /> <br />C.1nsert shims at the head of the window between the frame and the opening at <br />each pre-drilled installation hole, while the exterior flange is being pressed tightly <br />to the opening. <br />Not~: Then! should be DO more than 114" ckarance betwt!en th~ window /i-ame <br />and opBdng at any point along the bMd of the window. <br /> <br />D.1nstan a 3/16" x 2-3/4" Tapcone stainless steel masonry screw into each of the <br />pre-drilled holes in the window frame. Drive the screws until they are flush with the <br />frame. Over tightening may cause the frame to become distorted. <br /> <br /> <br /> <br />L"," ,!",',' <br />;e~. <br />~6.X 2-~J <br /> <br />screw 1 <br /> <br />Not~ It wDJ be neces.rary to open 1M JWIting sash ofIM singk-bung and sliding window to access <br />on~ or more of 1M installation bola <br /> <br />E. Tool the sealant squeeze out to provide a seal between the flush flange and the block or stucco. <br /> <br />R Single-hung Windows: Insert foam plugs (provided) into each installation screw hole <br />at the jambs and screw covers (Provided) into each installation screw hole at the head. <br />SUding and Fixed Windows: Insert a screw cover (Provided) into each installation <br />screw hole at the head and jambs. <br /> <br /> <br />[i' <br />i <br />i <br /> <br />It <br />i <br />