07-6612 - Laserfiche WebLink

Browse Search

Fully Sheathed Wall Installation The wall framing is c:overedby sheathing, and the window sits flush inside the rough opening. Open-Stud Installation Open-stud Installation is common in the SouthweSt and typically used with traditional stucco exteriors. Wall framing is not covered by sheathing. Block Wall Installation n assumes that a framework of 2x studs buck) are fastened and sealed to the my wallwith threa beads of sealant (use mended for concretelwood joints and ref's instruations). The comer joints of k must also be sealed. We will refer to of studs as the rough opening. PrecaiJtions & Safety General P ecautions ~ Do not work alone; we reco end using at least two people for installation to avoid person I injury or damage when workin with windows ~ Use ca tion when handling glass; ~roken or cracked glass can cause serious injury ~ Wear necessary protective gear (gloves, clothi~, goggles, etc.) ~ Avoid ~earing rings, jewelry or loose clothing ~ Secure tools when working on a ladder or scaffol ing ~ Secur ladders or scaffolding; follow equipment manu cturer's operation instructions, warnings, ~ and ca tions ~ Secur and properly support the window until compl tely fastened - Materials I ~ Alwa~ read and understand all manufacturer's labels. efore beginning ~ Heed II manufacturer's warnings and cautions ~ Care lly follow manufacturer's application instru tions ~ Prope ly dispose of unused products and waste materi I per federal, state, and local enviro ental protection rules Handling Materials ~ Protect exposed adhesive surfaces from dust/dirt prior to application Note: Temperatures below 320 may cause adhesive flashing materials to shrink and buckle away from backing paper. If this happens, make sure adhesive surfaces are protectedfrom debris. Do not expose adhesive flashing materials to direct sunlight for more than six weeks during storage Apply self-adhesive flashing to surfaces that are dry and frost-free After removing backing paper from adhesive flashing materials, do not allow them to fold over and adhere to themselves Press adhesive flashing materials onto surfaces with a j-roller Cut and roll flat any adhesive flashing edge buckle Do not allow any gaps or bubbles beneath adhesive flashing seal (remove and replace flashing if necessary) Avoid "over-spraying" adhesive onto surfaces not to be covered by adhesive flashing (e.g. glass) ~ ~ ~ ~ ~ ~ Door Product ~ Handle in vertical position ~ Do not drag on floor ~ Do not put stress on joints, comers, or frames ~ Store window in dry, well-ventilated area in near vertical, leaning position and allow air circulation; do not stack horizontally Protect from dust, water, and other contaminates Protect from exposure to direct sunlight Protect from accidental damage from wind and other job-site damages ~ Install only on vertical walls ~ Install only in dry conditions and when sheathing is completely dry ~ ~ ~ I I I nI012 InstJlation Instructions for Primed Wood Windows without Applied Exterior Trim Page 2