VECTOR SECURITY - Laserfiche WebLink

Browse Search

08130 Release Module Specifications Features . Two Form C, 5 Amp rated contacts . Supervised disable switch for system testing . Easy to install . Remote control of fire system devices . Instant or delayed relay activation and restoral . Compatible with D8112, 08112E & G Series, 09112, D9112B1, D7212, D7212B1, D7412, and D9412 control/ communicators . Relay closure follows indicating circuit duration Description The D8130 Release Module is an accessory for Radionics Rre Alarm Control/Communicators. The 08130 is suitable for release applications commonly found in NFPA 72 Local Fire Alarm Installations. Two independent Form C dry contacts, each rated at 5 Amps, connect low voltage circuits to magnetic door holders, pilot relays, or contractor units, for release function control. Contact activation on alarm is jumper selectable to be either instant or delayed by ten seconds. If the delay option is selected, a ten second delay also occurs upon restoral. The control/communicator indicating output activates the contacts of the D8130. A red" ALARM INPUT' LEO is provided on the 08130 module to indicate contact activation. The duration of the contact activation follows the programmed indicating circuit time. If the user silences the alarm output, the 08130 contacts are deactivated. Latching features must be provided for pilot relays or contractor units requiring release control beyond the programmed indicating device time or after manual silencing of the indicating circuits. Disable Switch To facilitate fire alarm installation testing, the 08130 Module contains a supervised disable switch that prevents release operation. An amber "OISABLE" LEO is provided on the D8130 to indicate when the switch is in the OISABLE position. The D8130 is connected to any unused protective zone or point of the control/communicator to supervise module disabling. A trouble is indicated on the controVcommunicator when the 08130 switch is in the DISABLE position, and a restoral is sent when the switch is retumed to the NORMAL position. When the contacts are activated with the switch in the NORMAL position, no trouble indications are sent to the control/communicator. D8130 Release Module Release Contact Outputs A normally open (NO) terminal, a normally closed (NC) terminal, and a common (COM) terminal are provided for each 08130 release contact. Silk screened markings on the edge of the circuit board clearly identify each terminal. In the inactive state of the contact, the NC terminal has continuity with the COM terminal. In the active state of the contact, the NO terminal has continuity with the COM terminal. Application The D8130 Release Module is used as a control/ communicator accessory to provide system control functions commonly required in NFP A 72 fire alarm installations. Typical applications are releasing fire doors, emergency exit doors, stairwell doors, elevator recall, smoke exhaust functions, and HV AC control. Installation The 08130 Release Module mounts in the control/ communicator enclosure or in a separate approved enclosure. Up to four modules can be installed using the mounting locations provided. A D138 Mounting Bracket is required to mount the D8130 in the D9124. Install, test and maintain this device according to the Installation Guide, NFPA 72, Local Codes and the Authority Having Jurisdiction. Failure to follow these procedures may result in failure of the device to operate properly. Radionics is not responsible for devices that are improperly installed, tested and maintained. Wiring to Control/Communicator Four wires from the D8130 module common (1 COM), altemate alarm output(2 ALT ALRM), +12 VDC (3 AUX PWR), and protective point (4 SWITCH SUPERVISION POINT) terminals connect to the controVcommunicator. These wires connect to the terminal block on the D8130. ~ Radonics.