08-7402 - Laserfiche WebLink

Browse Search

MATERIAL COVERAGE The number of various sized fittings that may be coated with one 50mL, and one 250mL tube of PERMABOND LHOSO Pipe Sealant are shown: Fittinq Size, inches Volume, mU100 Piec;,es Usage, Pieces/50 mL Usage, Pieces/250 mL 0.125 7,25 700 3450 0.25 9.66 500 2600 0,375 12,05 400 2100 0,5 14.05 340 1700 0.75 19.3 260 1300 1.0 24.2 200 1000 APPLICATION & DISPENSING 1, For best results, clean all surfaces with a cleaning solvent and allow to dry. 2, If the substrates being used are inactive metals or the cure speed is to slow, then spray the parts with ASC10 and allow to dry. 3. Apply a bead of the sealant 360. around leading threads 0 the male fitting leaving the first thread free of sealant. Force the material into all the voids, Adjust amount of sealant according to the size of the fitting, For large diameter pipe sealant may have to be applied to the female threads. 4, Assemble and tighten the fittings until proper alignment is obtained, Visually check for a small bead of sealant around the entire circumference of the pipe, 5. A seal to moderate pressure is obtained immediately on properly tightened fittings. Allow the sealant to cure for at least 24hours to obtain maximum pressure and chemical resistance. PERMABOND LHOSO pipe sealant may be readily dispensed out of the tube, or brush-top bottle. When using the tube package size, the convenient flip-top may be used to spread the sealant directly on to the first two-three threads of the male-component fitting, For larger volumes, the brush-top applicator may be used to "paint" the adhesive on to the first two-three threads of the male-component fitting, Following sealant application, tightening the fittings by hand, or using a wrench will complete assembly, Adjustments may be made up to 10 hours after assembly, without affecting the performance properties of the cured seal. STORAGE & HANDLING PERMABOND LHOSO pipe sealant should be stored in the original unopened container in a cool place away from sparks, flame, excessive heat and sunlight. Handling should be done using plastic gloves and proper eye protection, Skin contact should be avoided. If skin contact occurs, the affected area should be washed thoroughly with soap and water, Eye contact should be treated by thorough washing with water followed by medical attention. Adequate ventilation is necessary to prevent inhalation of vapors, Proper Personal Protective Equipment is always recommended when using chemicals. For more information, consult the Material Safety Data Sheet. PERMABOND LHOSO pipe sealant has a shelf life of one year when stored at or below 2rc (80.F), For packages greater than 1 litter the shelf life is 6 months from the date of shipment from Permabond. Do not freeze, Product removed from original container might be contaminated during use. Do not retum this material to the original container. FOR INDUSTRIAL USE ONLY. KEEP OUT OF REACH OF CHILDREN, Ref.#: 110607PBLH050 4