Laserfiche WebLink
<br />--_.__.._....~~_.m.__..~.__...,._......~_...._m^'" <br /> <br />I <br />) I <br /> <br />POSITIVE LOCK, INC. <br />800-342-7670 <br /> <br />INSTALLATION INSTRUCTIONS FOR TIME DELA Y LOCK <br /> <br />1. MAGNETIC ALARM I WEATHER STRIP <br /> <br />There must be a 4" clear surface in the corner of the doorjamb to allow for a flush <br />mounting of the TDL Latch Housing. The magnetic alarm will probably have to be <br />moved over, and the weather strip must be removed in the comer of the doorjamb. <br /> <br />2. LOCK INST AUlA nON <br /> <br />Install the Positive Lock Panic Hardware per the instructions in the hardware package <br />included with each lock. Any existing hardware must be removed before the installation <br />of the Positive Lock. <br /> <br />.*KEEP DOOR LOCKED FOR THE FOLLOWING ** <br /> <br />~ <br /> <br />! <br /> <br />.. <br />J. <br /> <br />INSTALLATION OF TDLLATCH HOUSING <br /> <br />The flex-hoses and wiring are connected between the Contro.l Panel and Latch Housing, <br />so place the Control Box on top of a ladder or tie it to a Conduit Pipe to eliminate having <br />to hold it. TIris is a closed I.oop system. The alarm will sound immediately when <br />powered if any wires are pulled loose. <br /> <br />, <br /> <br /> <br />I <br />i <br />I <br />i <br />I <br />I <br />I <br />i <br /> <br />Loosen the two Yo.20 nuts on the top end of the latch housing just enough to slide out the <br />bottom latch cover enough to see the mounting hole. Insert the Locking Plunger <br />(included in hardware pkg.) in the housing. Place the Latch Housing, with plunger <br />inside, against the latch side and top comer of the doorjamb pressing against the door. <br />The top-mounting bracket may be adjusted. by loosening the two nuts and sliding back <br />and forth for the thickness oftbe doorframe. Make sure the plunger toucbes the door. <br />Mark the mounting hole (closest to the door) up through the body of the Latch Housing. <br />Drill the mark with a Yo" bit and insert a blue anchor. Place tbe long 2 Yz" screw through <br />the body of the Latch Housing, tighten the screw. Make sure the top-mounting bracket is <br />against the front face ofthe doorjamb. Mark the two Mounting Holes. Drill the two <br />marked holes W' and insert two blue anchors. Insert two 1" screws through the mounting <br />bracket and tighten. Tighten the two ~-20 nuts holding the bracket. Slide the bottom <br />latch cover back into place under the lip and tighten the two nuts back into place. <br /> <br />~ <br />I <br />i <br /> <br />): <br />14 <br /> <br />4. <br /> <br />FLEX HOSE AND WIRING TO POSITIVE LOCK <br /> <br />Remove nut on the Flex Hose C.onnector on the bottom of the wires going down to <br />Positive Lock Panic Hard\\-'aI'e. Insert the \vires and end of connector into the bottom <br /> <br />I'."'............ <br />, <br /> <br /> <br />I <br />