08-8004 - Laserfiche WebLink

Browse Search

hoie of the 'black alann cover. Assemble the connector. making sure the Stainless Flex Hose does not extend more than W' past the fitting. Connect the wiring to the Terminal Strip inside the alarm assembly. The wiring strip connections are color indicated, Install the knockout'seal (included in hardware pkg.) in the top hole of the black alann cover. The flex hose will need to loop down from the black alarm box 6" to allow for the opening oithe door. This loop will keep the wires from pulling loose when the door is opened. Once again, this is a closed loop system and the alann win sound immediately when powered if any wires are pulled loose. Take one of the Clamps and using the Self-Tapping Screws, attach the Flex Hose to the doorjamb at the height of the black alarm box. Open the door to make sure it win open completely. Adjust your Flex Hose loop accordingly. You can now mount the other Flex Hose Clamps to secure the Flex Hose to the doorjamb. 5. CONTROL PANEL INSTALLATION i ! 1 I I I I I The Control Box should be centered above the pair of doors or single door for the Flex Hose to be the appropriate length. The Control Box has two external mounting brackets to fasten it to the wall. Mark the two holes from the mounting brackets located on the top and bottom of the Control Box. Drill the two marked holes W' and insert two of the blue anchors. Insert two 1" long screws through the mounting brackets and tighten. Secure the Flex Hose to the wan as needed using the Cable Clamps. 6. LATCHING PLUNGER INSTALLATION Unlock and open the door. Place the Transfer Pin (included in marked box) in the end of the Plunger, which is in place in the Latch Housing. Slam the door closed to mark location.. Open the door; check to make sure the pin marked the door. Remove the Transfer Pin and save for the next installation. Drill the marked spot with a W' pilot bit completely through the door, You will now use the pilot hole and drill with a 3/8" bit through the door. Using the 3/8" bit, ream the hole on the outside shell only. This is to allow the 3/8" Elevator Bolt to seat properly without distorting the door. Place the Elevator Bolt, head outside. through the door. Place the large flat washer over the threads of the Elevator Bolt then remove the Plunger from the Latch Housing and screw it completely onto the Elevator Bolt. The smaller flat washer may be needed iithe door has warped and is pulling away from the frame. Tighten the SetScrew into the Plunger - this may need to be adjusted later if the door does not stay locked for 15 seconds. 7. ELECTRICAL CONNECTION You are now ready for 110 volts to be connected to the Control Box. The connection wires are in the junction box on top of the Control Box. The white and black wires are for 110 volts. The green wire is ground. The blue and red wires are for the 24 volt frre ~