10-10233 - Laserfiche WebLink

Browse Search

G310A -A Revised February 20, 2007 Page 21 TROUBLESHOOTING GUIDE If there is NO gas flow to the stove, verify that the • (continued) gas valve is plugged into the Gas Shut Off Assembly control box. CAUTION: DURING CHECK OUT (The gas valve is normally closed and is PROCEDURES MAKE SURE SAFETY PULL energized when power is supplied to it.) PIN IS INSTALLED. • If there is still NO gas flow, unplug the gas valve Confirm that the installation of Sonic Receiver is and measure for 24 VAC voltage between the • black and white wires. If there is voltage not obstructed from receiving the audio signal. measured at the connector, replace the gas Verify that the location and the db level valve. (loudness) is adequate by opening cabinet. If electric shutoff activates, installation of a remote NOTE: After performing the above steps and there is alarm may be necessary to compensate for the 24VAC at plug and if the gas flow indicator light is not type of cabinet or an Interconnect Cable will have lit indicating gas flow, check the bulb indicator light. It to be used. may need to be replaced. • If any unknown interference occurs from a site • If there is NO voltage at the connector that condition the Interconnect Cable may have to be plugs into the valve, replace the Gas Shutoff used. Control box. Gas Shutoff (P/N G316 - A) Problem: No Shutoff Activation - Interconnect Problem: No Electrical Power To Stove • Cable or the Sonic Receiver Assy.. Confirm power is supplied at the wall outlet. If no Confirm that power is supplied to "Gas Shutoff • power to the stove exist, check the site condition. Control Box ". If no power exist, perform the steps under "No Electrical Power to Stove" on If power exist at the wall outlet, unplug the stove Page 20. • from wall outlet and plug it into Gas Shutoff • Perform the TEST PROCEDURES for either the Control box. INTERCONNECT CABLE or SONIC RECEIVER ASSEMBLY on Page 16 &17. • Verify that the "Power Reset" push button switch • If no activation, replace the gas shutoff. is pushed. Electrical power is supplied to the stove. (See FIGURE 18) Sonic Receiver Assy (P /N G315 -A) • DO NOT push the "VALVE RESET" switch at this Problem: No Sonic Activation time. Pushing the VALVE RESET switch will enable gas to flow to the stove. • Perform "Sonic Receiver Test Procedures" • If power still does NOT exist to the stove, unplug Checkout on Page 16. stove from the Gas Shutoff Control box and check for 115 VAC on the control box outlet. If • Check that "Sonic Receiver Assembly" is plugged there is no power, replace the control box. into either the gas or electric shutoff. Power "ON" light will be lit. This indicates power is Problem: No Gas Flow to Stove being supplied to the Sonic Receiver board. • Confirm that the installation of Sonic Receiver is • Confirm that the "source power" is supplied to the not obstructed from receiving the audio signal. Gas Shutoff Control box. Verify that the location and the db level (loudness) is adequate by opening cabinet. • Verify that the "Power Reset" push button switch is pushed to supply power to the stove and to the • If shutoff activates by increasing the db level of the "Valve Reset" switch on the Gas Shutoff sound, installation of a Remote Alarm may be Control Box. necessary to compensate for the type of cabinet. (The Power Reset switch supplies power to the Valve Reset Switch. This is a safety feature.) • If the db level of loudness is adequate, replace Push the "Valve Reset" switch for gas flow to the Sonic Receiver board or substitute an • the stove. The gas flow indicator light is lit. Interconnect Cable in place of the Sonic Receiver Assembly. • If any unknown interference occurs from a site condition the Interconnect Cable may have to be used. See Page 8 &16.