10-10321 - Laserfiche WebLink

Browse Search

AES 7788 Series RF Subset iber Unit — Installation and Opel ation Manual 1.8 Technical Specifications ♦ SIZE.: 13.25 "h X 8.5 "w X 4.3 "d (34 cm X 21.5 cm X 11 cm) excluding antenna • WEIGHT: 5.8 pounds (2.6 kilograms) Without Battery (Add 6 pounds with Battery) • POWER INPUT: I6.5VAC, 40VA class 2 (dry) source only ♦ VOLTAGE: 12VDC nominal • CURRENT: 150 mA standby; 1 2A transmit ♦ CURRENT with 7067/7770: 210 mA standby; 1.3 A transmit (2 Watt Transceiver) • OPERATING TEMPERATURE RANGE: 0° to 49° C (32° to 120 °F) • STORAGE TEMPERATURE. RANGE: -10° to 60° C (14° to 140 °F) ♦ RELATIVE HUMIDITY RANGE: 0 to 85% RHC, Non Condensing • BACK -UP BATTERY: 12V, 7 5AH (Min) (24 Flour standby), lead acid gel type; required for all installations • BATTERY FUSE: Onboard self - resetting fuse. Not serviceable ♦ ALARM SIGNAL INPUTS: 8 Supervised individually programmable Zones: All 8 are EOL. type with, Trouble & Restore • LOW BATTERY REPORTING: Below 1 I V. 2.75 Minute Test Cycle (approx) • AC FAILURE REPORTING: AC Fail messages are queued for transmission to central station after approximately 100 continuous minutes without AC power Transmission to central station is then delayed randomly between 0 to 60 minutes. Restore is similar with Restore message queued for transmission after approximately 100 continuous minutes with AC power restored. AC Fail /Restore messages will be sent between 100 and 160 minutes after the failure or restore occurs that remains for 100 minutes. See Section 4.3 - Timine Parameters for additional information and programming options ♦ ANTENNA CUT / LOW BATTERY / CHARGER FAIL LOCAL. REPORTING: Normally Open Relay contact at 14. Relay is engaged for normal operation. Disengages on Reset, Antenna Cut/Acknowledge Delay. power loss condition. low battery or charger fail. Contact rating — 24 VDC 1 -Amp max, Not Supervised. • RESET BUTTON: Located on the PCB. • TRANSCEIVE.R: • Standard UHF Frequency Ranges (410- 440MHz, 440- 470MHz, 470-5I2MHz) • TRANSCEIVE.R FUSE.: 400 milliamp PTC. Not serviceable • STANDARD RF OUTPUT POWER: 2 Watts ♦ Zones 1 -8: dry contact supervised with 2.2K EOL resistor ♦ GROUND FAULT: A ground fault as tested by UL., is when an isolated ground terminal ofa Supervised zone labeled "G" is less than 0 1 Ohm impedance to Earth Ground. A zone 10 Trouble is transmitted for this fault_ The CID message generated at alarm automation for a Ground Fault in a 7788E is E370 C010. ♦ BATTERY CHARGE FAIL.: 7788F monitors Charger Voltage and reports a Fault when the voltage from the charger gets to low. A zone 9 Trouble is transmitted for this fault The CID message generated at alarm automation for a Charger Fault in a 7788F is E370 C009 AES Corporation 7 40 -7788. Rer 3a. 4/9/2009