Laserfiche WebLink
.4ES 7788 Series RF Srrbscribei Unit -- Installation and Operation Manual <br /> 1.5 RF Module (Transceiver) <br /> Each 7788F Unit includes an RF Module known as a transceiver along with a standard <br /> tamper resistant 2.5 dB flexible omni - directional antenna. The standard antenna supplied <br /> is for the frequency range of 450- 480MHz. Contact AES for additional information on <br /> available Models for use with other Non -UL frequencies and antennas. <br /> See UHF Antenna Options in Section 1.9 <br /> 1.6 Optional Accessories <br /> 7041 — Hand Held Subscriber Programmer <br /> 7067 — AES IntelliTap module <br /> 7770 — AES FireTap module <br /> 1.7 Safety Considerations <br /> ♦ All equipment must be installed in accordance with National Electric Code, <br /> NFPA 70, National Fire Code NFPA 72 and local building codes. <br /> ♦ It is unlawful to operate this equipment in the USA without a valid FCC radio <br /> station license. Other countries most likely require licensing through appropriate <br /> authorities as well. <br /> ♦ Be certain to properly ground the antenna, 7788E enclosure and any surge <br /> protection devices to help dissipate surges away from the equipment and <br /> personnel. The grounding of the antenna and surge protector is for your safety <br /> and the safety of your equipment and should not be neglected. <br /> ♦ If the antenna or cables connected to this equipment come in contact with <br /> electrical power lines, DEATH or SERIOUS INJURY may result. <br /> ♦ Test this system periodically for proper operation. AES assumes no responsibility <br /> for this equipment's failure to operate. AES' sole responsibility is to repair or <br /> replace any AES device found to be defective during the warranty period <br /> ♦ Exposure to extreme cold below 0 °C or extreme hot above 50 °C could damage <br /> any Gel battery used in the installation of this product. Extreme temperatures can <br /> also cause unexpected operation of the electronics <br /> ♦ Exposure of the electronics to excessive water or moisture (such as a rain, shower, <br /> bath, pool, sauna, etc) could cause damage and unexpected operation. <br /> ♦ Avoid dropping or other physical impact to the unit, which could damage the <br /> enclosure or internal components. <br /> AES Corporation 6 40 -7788. Rev 3a. 4/9/2009 <br />