Laserfiche WebLink
AES 7758 Series RF Subscriber Unit -- Installation and Operation Manual <br /> 2 Commercial Fire and Burglary Installation Notes <br /> UL Burglar Installations Tamper Protection: A UL Listed tamper switch that protects <br /> the cover against opening or removal is required on the 7788F installed in a burglar alarm <br /> installation. If the 7788F is installed outside the protected area, a tamper device is <br /> required to protect the enclosure against removal from the mounting surface. <br /> Use a UL approved plunger type tamper switch, installed using holes drilled by the <br /> installer through the side and rear of the enclosure as suggested in Diagram below. Refer <br /> to diagram below, actual selected UL Listed tamper device and manufactures <br /> documentation for installation instruction and required hole pattern. <br /> Wire tamper devices to a zone as outlined in the tamper device manufactures <br /> documentation and section 3. <br /> The tamper devices must be installed and wired to activate a zone on the subscriber to <br /> generate an alarm signal at the central station. <br /> In addition to installing tamper devices on the 7788F, a motion detector connected to the <br /> alarm control panel is required to protect the 7788F against attack. <br /> The 5 shaded holes shown in the diagram to the left <br /> indicate suggested locations for holes needed to <br /> install a typical UL Listed plunger type tamper <br /> switch. <br /> Actual dimensions are to be determined from the <br /> 7 actual switch and or switch installation instructions. <br /> Although the typical switch has three mounting <br /> holes available, two are sufficient to securely mount <br /> 0 the switch. <br /> A typical plunger type switch requires a 3/8" hole <br /> centered at the location where the plunger can <br /> IL01 protrude unhindered through the rear of the <br /> enclosure to make contact with the enclosure's <br /> mounted surface. <br /> O <br /> Several plunger type Tamper switches are shown <br /> above. The switch on the left is the style selected <br /> for the suggested hole patterns in the diagram to the <br /> left. The switch style on the right with built in <br /> mounting flange allows installation of a cover <br /> tamper without the need to drill holes_ <br /> � <br /> Suggested Tamper Switch Mounting Locations <br /> AES Corporation 9 40-7788. Rev 3a. 4/9/2009 <br />