Laserfiche WebLink
Chapter 4 — System Installation <br /> Page 4 -1 <br /> REV. 2 <br /> CHAPTER IV <br /> SYSTEM INSTALLATION <br /> This chapter will detail the basic information necessary for The cylinder must be mounted vertically with the discharge <br /> proper installation of the PYRO -CHEM Open Face Paint port facing either left or right. The Models PCI- 15ABC, <br /> Spray Booth Industrial Fire Suppression System. However, PCI- 17ABC, and PCI- 25sABC cylinders must be mounted <br /> before attempting any installation it is necessary to attend a using a Model MB -15 Mounting Bracket Kit. The Model <br /> Factory Certification Training Class and become Certified to ■ PCI- 35ABC, PCI- 50sABC, and PCI -70ABC cylinders must <br /> install the PYRO -CHEM Industrial Open Face Paint Spray be mounted using a Model MB -1 Mounting Bracket Kit. <br /> Booth Fire Suppression System. The bracket must be securely anchored to the wall using <br /> bolts or lag screws. The wall to which the bracket is <br /> Pipe and fittings for the discharge piping, conduit (EMT), attached must be sufficiently strong to support the cylinder. <br /> pipe straps, pipe hangers, mounting bolts, and other miscel- The bracket should never be fastened to dry wall or similar <br /> laneous equipment are not furnished as part of the material. If this type of wall is encountered, studs must be <br /> PYRO -CHEM Open Face Paint Spray Booth Industrial Fire located and the bracket fastened to them. See Figure 4 -1. <br /> Suppression System. These items must be furnished by the <br /> oio <br /> installer. a <br /> Iwo <br /> STRAP <br /> Before attempting any installation, unpack the entire system irta MOUNTING • <br /> and check that all necessary parts are on hand. Inspect `,/ BRACKET <br /> parts for damage. Verify that cylinder pressure is within the � �, <br /> acceptable range as shown on the gauge. <br /> CYLINDER INSTALLATION CYLINDER <br /> MOUNTING HOLES The cylinder and valve assembly is shipped with an anti- * * 4 1 r� <br /> recoil plug in the valve discharge port. <br /> Figure 4 -1. Cylinder and Mounting Bracket Installation. <br /> CAUTION 002871 PC <br /> The anti - recoil plug must remain in the valve dis- <br /> charge port until the discharge piping is connected to CONTROL HEAD INSTALLATION <br /> the valve. <br /> 1. Single Cylinder Installations. <br /> For single cylinder system installations the Model <br /> MCH3 /ECH3 /NMCH3 Control Head can be installed directly <br /> onto the cylinder valve. When the control head is properly <br /> aligned in the desired position, tighten the knurled locking <br /> ring to secure the assembly. See Figure 4 -2. <br /> I PULL PIN PULL STA-: r R NG <br /> los �( -orJ tR1 -PJ <br /> • -4//aiiarUNINIV, 11 <br /> RE.NMITE <br /> ��- <br /> PULL. . STA -',ONN ;P:V.; : tic <br /> T Rv) NAT'. ON ..:.a.S.,r <br /> _ KNURLED <br /> LOCKING <br /> 11::/1.(1)..11 RING <br /> Figure 4 -2. Single Cylinder Installation Using Model MCH3 /ECH3 Control Head. <br /> 002872PC/003647PC <br /> ULEX 3437 CEx732 <br /> March 17, 2004 <br />