10-10030 - Laserfiche WebLink

Browse Search

SYSTEM SPECIFICATIONS System Capacity 16.65" (42.29 cm.) wide x 5.20" (13.34 cm.) deep. Trim Ring (TR- CE -B): 22.00" (55.88 cm.) high x 19.65" (49.91 cm.) wide. • Intelligent Signalling Line Circuits 1 • Addressable device capacity 198 Shipping Specifications • Programmable software zones 99 • ACS Annunciators 32 Weight: 26.9 lbs. (12.20 kg.) Dimensions: 20.00" (50.80 cm.) high x 22.5" (57.15 cm.) wide x 8.5" (21.59 cm.) deep. • ANN -bus devices 8 Electrical Specifications Temperature and Humidity Ranges This system meets NFPA requirements for operation at 0 - AC Power: FireWarden -100 -2 Rev 2: 120 VAC, 60 Hz, 3.0 49 °C/32 -120 °F and at a relative humidity 93% ± 2% RH amps. FireWarden -100 -2 Rev 2(E): 240 VAC, 50 Hz, 1.5 amps. (noncondensing) at 32 °C ± 2 °C (90 °F ± 3 °F). However, the Wire size: minimum 14 AWG (2.00 mm with 600 V insulation. useful life of the system's standby batteries and the electronic Battery: Two 12 V 18AH lead -acid batteries. components may be adversely affected by extreme tempera - Battery charger capacity: 7 -18 AH. FireWarden -100 -2 Rev ture ranges and humidity. Therefore, it is recommended that 2 cabinet holds maximum of two 18 AH batteries. this system and its peripherals be installed in an environment with a normal room temperature of 15 - 27 °C /60 - 80 °F. Communication Loop: Supervised and power - limited. Notification Appliance Circuits: Each terminal block pro- NFPA Standards vides connections for two Style Y (Class B) or one Style Z (Class A) for a total of four Style Y (Class B) or two Style Z The FireWarden 100 2 Rev 2 complies with the following (Class A) NACs. Maximum signaling current per circuit: 2.5 NFPA 72 Fire Alarm Systems requirements: amps. End -of -Line Resistor: 4.7K ohm, 1/2 watt (P /N 71252 - LOCAL (Automatic, Manual, Waterflow and Sprinkler UL listed) for Style Y (Class B) NAC. Refer to panel documen- Supervisory). tation and Notifier Device Compatibility Document for listed - AUXILIARY (Automatic, Manual and Waterflow) (requires compatible devices. 4XTM). Two Programmable Relays and One Fixed Trouble Relay: - REMOTE STATION (Automatic, Manual, Waterflow and Contact rating: 2.0 amps @ 30 VDC (resistive), 0.5 amps @ 30 Sprinkler Supervisory) (Where a DACT is not accepted, VAC (resistive). Form -C relays. the alarm, trouble and supervisory relays may be con - Special Application Power (24 VDC Nominal): Jumper nected to UL 864 listed transmitters. For reverse polarity selectable (JP4) for conversion to resettable power output. Up signaling of alarm and trouble, 4XTM is required.) to 0.3 amps total DC current available from each output. - PROPRIETARY (Automatic, Manual, Waterflow and Power - limited. Sprinkler Supervisory). Four -Wire Resettable Special Application Smoke Detector - CENTRAL STATION (Automatic, Manual, Waterflow and Power (24 VDC nominal): Up to 0.3 amps for powering four- Sprinkler Supervisory). wire smoke detectors. Power - limited. Refer to the Notifier - OT, PSDN (Other Technologies, Packet - switched Data Device Compatibility Document for listed compatible devices. Network) Remote Sync Output: Remote power supply synchronization output. Nominal special application power: 24 VDC. Maximum Agency Listings and Approvals current: 40 mA. End -of -Line Resistor: 4.7K ohm. Output linked to NAC 1 control. Supervised and power - limited. The listings and approvals below apply to the basic FireWar- den -100 -2 Rev 2 control panel. In some cases, certain mod - Telephone Interface: Unless used with Teldat VISORALARM, ules may not be listed by certain approval agencies, or listing requires dedicated business telephone number with a mini- may be in process. Consult factory for latest listing status. mum of 5 volts DC (off -hook voltage). Obtain dedicated phone • UL: S635 line directly from your local phone company. Do not use shared phone lines or PBX (digital) type phone line extensions. • FM approved • CSFM: 7165- 0028:235 Cabinet Specifications • MEA: 120 -06 -E, Volume 2 Door: 19.26" (48.92 cm.) high x 16.82" (42.73 cm.) wide x 0.12" (.30 cm.) deep. Backbox: 19.00" (48.26 cm.) high x FireWarden® and Notifier® are registered trademarks of Honeywell International Inc. Microsoft® and Windows® are registered trademarks of the Microsoft Corporation. ®2009 by Honeywell International Inc. All rights reserved. Unauthorized use of this document is strictly prohibited. 1S0 9001 This document is not intended to be used for installation purposes. We try to keep our product information up -to -date and accurate. C E R T 1 F 1 E We cannot cover all specific applications or anticipate all requirements. B EREMIIR ` AWARMIIIM6 All specifications are subject to change without notice. QUALITY SYSTEMS Made in the U.S. A. For more information, contact Notifier. Phone: (203) 484 -7161, FAX: (203) 484 -7118. www.notifier.com Page 6 of 6 — DN- 60417:C • 12/17/2009