10-10030 - Laserfiche WebLink

Browse Search

do 6999:b1 Monitor Modules NMM- 100(A), NMM- 100P(A), NZM- N OT I F 1 E R 100(A ), and NDM-100(A) for FireWarden Series Panels by Honeywell Intelligent Addressable Devices General Four different monitor modules are available for Notifier's Fire- Warden Series intelligent control panels for a variety of appli- cations. Monitor modules supervise a circuit of dry- contact r t input devices, such as conventional heat detectors and pull, stations, or monitor and power a circuit of two -wire smoke's t i detectors (NZM- 100(A)). ,a .., t x NMM- 100(A) is a standard -sized module (typically mounts to a 4" [10.16 cm] square box) that supervises either a Style D (Class A) or Style B (Class B) circuit of dry- contact input devices. gra NMM- 100P(A) is a miniature monitor module a mere 1.3" 71.k., ,wt'ra (3.302 cm) H x 2.75" (6.985 cm) W x 0.5" (1.270 cm) D that of supervises a Style B (Class B) circuit of dry- contact input devices. Its compact design allows the NMM- 100P(A) to often be mounted in a single -gang box behind the device it monitors. NZM- 100(A) is a standard -sized module that monitors and supervises compatible two -wire, 24 volt, smoke detectors on a Style D (Class A) or Style B (Class B) circuit. NDM- 100(A) is a standard -sized dual monitor module that NMM- 100(A) (Type H) monitors and supervises two independent two -wire Style B (Class B) dry - contact initiating device circuits (IDCs) at two separate, consecutive addresses in intelligent, two -wire systems. NMM- 100(A) OPERATION Each NMM- 100(A) uses one of the available module NMM- 100(A) Monitor Module addresses on an SLC loop. It responds to regular polls from • Built -in type identification automatically identifies this device the control panel and reports its type and the status (open/nor- as a monitor module to the control panel. mal /short) of its Initiating Device Circuit (IDC). A flashing LED indicates that the module is in communication with the control • Powered directly by two -wire SLC loop. No additional power panel. The LED latches steady on alarm (subject to current required. limitations on the loop). • High noise (EMF /RFI) immunity. • SEMS screws with clamping plates for ease of wiring. NMM- 100(A) SPECIFICATIONS • Direct Decade entry of address: 01 — 99 on FireWarden- Nominal operating voltage: 15 to 32 VDC. 100 -2, 01 — 50 on FireWarden -50. Maximum current draw: 5.0 mA (LED on). • LED flashes during normal operation and latches on steady Average operating current: 350 pA (LED flashing), 1 com- to indicate alarm. munication every 5 seconds, 47k EOL. The NMM- 100(A) Monitor Module is intended for use in intelli- Maximum IDC wiring resistance: 40 ohms. gent, two -wire systems, where the individual address of each module is selected using the built -in rotary switches. It pro EOL resistance: 47K ohms. vides either a two -wire or four -wire fault - tolerant Initiating Temperature range: 32 °F to 120 °F (0 °C to 49 °C). Device Circuit (IDC) for normally- open- contact fire alarm and supervisory devices. The module has a panel - controlled LED Humidity range: 10% to 93% noncondensing. indicator. Dimensions: 4.5" (11.43 cm) high x 4" (10.16 cm) wide x NMM- 100(A) APPLICATIONS 1.25" (3.175 cm) deep. Mounts to a 4" (10.16 cm) square x 2.125" (5.398 cm) deep box. Use to monitor a zone of four -wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally- NMM- 100P(A) Mini Monitor Module open dry- contact alarm activation devices. May also be used • Built -in type identification automatically identifies this device to monitor normally -open supervisory devices with special supervisory indication at the control panel. Monitored circuit as a monitor module to the panel. may be wired as an NFPA Style B (Class B) or Style D (Class • Powered directly by two -wire SLC loop. No additional power A) Initiating Device Circuit. A 47K ohm End -of -Line Resistor required. (provided) terminates the Style B circuit. No resistor is • High noise (EMF /RFI) immunity. required for supervision of the Style D circuit. • Tinned, stripped leads for ease of wiring. • Direct Decade entry of address: 01 — 99 on FireWarden - 100-2, 01 — 50 on FireWarden -50. tln- 6999:b1 • 11/19/09 — Page 1 of 4