12-12735 - Laserfiche WebLink

Browse Search

DN-6995:C•Ai-320 NP-100(A) Series � N OT 1 F 1 E R° Addressable Photoelectric Detectors � for the FireWarden Series by Honeywell General The NP-100(A), NP-100T(A) and NP-100R(A) addressable, � I ` low-profile plug-in photoelectric detectors use a state-of-the- art photoelectric sensing chamber with communications to - provide open area protection and are used exclusively with � _ NOTIFIER's FireWarden Series(FireWarden-100-2 and Fire- Warden-50) and Spartan (NSP-25) Addressable Fire Alarm Control Panels (FACPs). The NP-100T(A) adds thermal sen- sors that will alarm at a fixed temperature of 135°F (57°C). _ Since these detectors are addressable, they will help emer- gency personnel quickty locate a fire during its early stages, potentially saving precious rescue time while also reducing property damage.Two LEDs on each sensor light to provide a � local,visible sensor indication.Remote LED annunciator capa- bility is available as an optional accessory, PN RA100Z(A). ° The NP-100R(A)is a remote test capable detector for use with NP-100(A) in 6210LP(A) Base m DNR(A)/DNRW duct smoke detector housings. Features Applications SLC loop Use photoelectric detectors in life-safety applications to pro- • Two-wire loop connection. vide a broad range of fire-sensing capability, especially where • Unit uses base for wiring. smoldering fires are anticipated. lonization detectors are often Addressing better than photoelectric detectors at sensing fast, flaming fires. • Addressable by device. • Rotary,decimal addressing:01–99 with FireWarden-100-2 Construction and NSP-25,and 01 –50 with FireWarden-50. These detectors are constructed of off-white fire resistant plas- Architecture tic. NP-100(A) series plug-in, low-profile smoke detectors are • Unique single-source, dual-chamber design to respond designed to commercial standards and offer an attractive quickly and dependably to a broad range of fires. appearance. • Sleek,low-profile design. • Inte ral communications and built-in Installation g type identification. • Built-in tamper-resistant feature. NP-100(A)series plug-in detectors use a detachable mounting • Removable cover and insect-resistant screen for simple base to simplify installation,service and maintenance. field cleaning. Mount base (all base types)on an electrical backbox which is Operation at least 1.5"(3.81 cm)deep.For a chart of compatible junction Withstands air velocities up to 4,000 feet-per-minute(20 M boxes,see DN-60054. • sec.)without triggering a false alarm. NOTE:Because of the inherent supervision provided by the SLC • Factory preset at 1.5% nominal sensitiviry for panel alarm �oop, end-of-line resistors are not required. Wiring `T-taps" or branches are permitted for Style 4(C/ass B) wiring. NP-100R(A) threshold level. mounts in a DNR(A)/DNRW duct detector housing. • Visible LED"blinks"when the unit is addressed(communi- cating with the fire panel)and latches on in alarm. �peration Mechanicals Each NP-100(A) series detector uses one of 99 possible • Sealed against back pressure. addresses on the FireWarden-100-2 and NSP-25,or one of 50 • Direct surface mounting or electrical box mounting. possible addresses on the FireWarden-50 Signaling Line Cir- • Mounts to: single-gang box, 3.5" (8.89 cm) or 4.0" (10 16 cuit (SLC). It responds to regular polls from the system and cm)octagonal box,or 4 0"(10 16 cm)square electrical box reports its type and status. (using a plasier ring—included) The addressable photoelectric sensor in the NP-100(A)series Other system features has a unique unipolar chamberthat responds quickly and uni- formly to a broad range of smoke conditions. It can withstand • Fully coated circuit boards and superior RF/transient pro- avind gusts up to 4,000 feet-per-minute (20 misec.) without tection. sending an alarm level signal. Because of its unipolar cham- • 94-VO plastic flammability rating. ber, the NP-100(A) series is approximately two times more • Low standby current. responsive than most photoelectric sensors. This makes it a Options more stable detector. • Remote LED output connection, PN RA100Z(A). DN-6995:C•12/07/2011—Page 1 of 2