14-15745 - Laserfiche WebLink

Browse Search

EE�G: Asbestos Surve October 7 2014 SECTI N 3.0 METHODS AN LIMITATIONS , 3.1 ASBESTOS SURVEY METHODS The demolition areas were inspected for suspe t ACM, unless otherwise noted. Each observed suspect material was assigned a homogenous area number, described, and measured. Each observed suspect material was either sampled r assumed to be asbestos-containing. Samples of suspect ACM were collected using proce ures established by the United States (US) Environmental Protection Agency (EPA) Code f Federal Regulations (CFR) Title 40 Part 763 Subpart E,Asbestos-Containing Materials in Sc ools. 3.2 LABORATORY ANALYSIS METHODS Samples were delivered to American Asbestos aboratories, Inc. in Tampa, Florida for analysis. Upon arrival at the laboratory, the samples w re logged-in and stored for analysis. Analyses were performed using the polarized light micro copy (PLM) method of asbestos detection using , guidelines and procedures established in the ethod for the Determination of Asbestos in Bulk Building Materials (EPA-600/R-93-116 July, 19 3). 3.3 LIMITATIONS This asbestos ins ection re ort has been re red b EE&G in a manner consistent with that P p P P Y level of care and skill ordinarily exercised by members of the profession currently practicing under similar conditions. No other warranty, e pressed or implied is made. The intent of this survey report is to assist the owner or client i locating ACM. Under no circumstances is this survey to be utilized as a proposal or a proje t specification document without the expressed written consent of EE8�G. The survey was conducted to identify suspect CM in accessible areas of the structure. If other areas at this location are to be impacted du ing planned or future renovations, a separate asbestos survey of these areas will be required Some ACM may not have been discovered due to inaccessibility or missing/incomplete plans. ny suspect materials discovered subsequent to the issue of this survey report should be samp ed and analyzed to determine asbestos content and to initiate appropriate responses. Analyses were carried out by PLM. While the most commonly accepted analytical method for detecting asbestos in bulk materials, PLM is known to have limited resolution and may not detect extremely small asbestos fibers. Certai materials, notably vinyl floor tiles, may contain extremely fine asbestos fibers that are beyond he resolution of PLM. EE&G's interpretations and recommendations are based upon the results of sample collection and analyses in compliance with environme tal regulations, quality control and assurance standards, and the scope of work as indicated in EE&G's proposal, dated September 19, 2014. The results, conclusions, and recommendatio s contained in this report pertain to conditions observed at the time of the survey. Other co ditions elsewhere in the subject building(s) may HUPP ZHILLS GALL BLVD SURVEY REPORT -�