18-20581 - Laserfiche WebLink

Browse Search

SYSTEM—SPECIFIC 6.5.4.4 Mechanical Temperature reset by representative building loads in pumping systems>10 hp for chiller and boiler systems>300,000 Btu/h. SYSTEM—SPECIFIC 6.5.4.5.2 Mechanical Hydronic heat pumps and water-cooled unitary air 0 El conditioners with pump systems>5 hp have controls or devices to reduce pump motor demand. SYSTEM—SPECIFIC 6.5.4.6 Mechanical . Chilled-water and condenser water piping sized El ED 11 according to design flow rate and total annual hours of operation(Table 6.5.4.6). SYSTEM—SPECIFIC 6.5.5.2.1 Mechanical Fan systems with motors>=7.5 hp associated with heat rejection equipment to have capability to operate at 213 of full-speed and auto speed controls to control the leaving fluid temperature or condensing temp/pressure of heat rejection device. SYSTEM—SPECIFIC 6.5.5.2.2 Mechanical Multicell heat rejection equipment with variable-speed fan drives installed that operate the maximum number of fans allowed that comply with manufacturers specs and control all fans to the same fan speed required for the instantaneous cooling duty. SYSTEM—SPECIFIC 6.5.5.2.3 Mechanical NA HVAC 6.5.7.1.1 Mechanical Ktchen hoods>5,000 cfm have make up air 1:1 El El >=50%of exhaust air volume. HVAC 6.5.7.1.1 Mechanical Kitchen hoods>5,000 cfm have make up air >=50%of exhaust air volume. SYSTEM—SPECIFIC 6.5.7.1.2 Mechanical Conditioned supply air to space with a kitchen hood shall not exceed the greater of a)supply flow required to meet space heating or cooling,or b)hood exhaust flow minus the available air transfer from available spaces. SYSTEM—SPECIFIC 6.5.7.1.3 Mechanical Kitchen hoods with a total exhaust airflow rate >5000 cfm meet replacement air,ventilation system,or energy recovery requirements shown in Table 6.5.7.1.3. SYSTEM—SPECIFIC 6.5.7.1.4 Mechanical Kitchen hoods with a total exhaust airflow,rate >5000 cfm meet replacement air,ventilation system,or energy recovery requirements. HVAC 6.5.7.2 Mechanical Fume hoods exhaust systems>=5,000 cfm have VAV hood exhaust and supply systems,direct make-up air or heat recovery. HVAC 6.5.8.1 Mechanical Unendosed spaces that are heated use only El El 0 radiant heat. SYSTEM—SPECIFIC 7.5.1 Mechanical Combined space and water heating system not 11 El El allowed unless standby loss less than calculated maximum.AHJ has approved or combined connected load<150 kBtu/h. Controls 8.4.2 Project At least 50%of all 125 volt 15-and 20-Amp El El El receptacles are controlled by an automatic control device. Other Equipment 10.4.1 Mechanical Electric motors meet requirements where 1:1 El El applicable. HVAC 6.4.3.3.2 Mechanical Setback controls allow automatic restart and 11 El El temporary operation as required for maintenance. SYSTEM—SPECIFIC 6.4.3.3.3 Mechanical Systems with setback controls and DDC include optimum start controls.Optimum start algorithm considers mass radiant slab floor temperature. SYSTEM—SPECIFIC 6.4.3.3.4 Mechanical Zone isolation devices and controls. 1:1 0 Wattage 9.4.2 Exterior Lighting Exterior lighting power is consistent with what is shown on the approved lighting plans, demonstrating proposed watts are less than or equal to allowed watts. 3To be checked by lnspector . EnergyGauge Summit®Fla/Com-2017.TAM 2017-1.0 Compliant Software.Effective Date:Dec 31,2017 Florida Building Code,Sixth Edition(2017)-Energy Conservation ASHRAE 90.1-2013-Prescriptive Compliance Option 7/6/2018 Page 11 of 21