19-20704 - Laserfiche WebLink

Browse Search

DONNELLY ENGINEERING ELECTRICAL 1.12 COORDINATION A. General: Compare drawings and specifications with those of other trades and report any discrepancies between them to the Engineer. Obtain from the Engineer written instructions to make the necessary changes in any of the affected work. All work shall be installed in cooperation with other trades installing interrelated work. Before installation, all trades shall make proper provisions to avoid interferences in a manner approved by the Engineer. B. Adjustments: Locations of conduit and equipment shall be adjusted to accommodate the work with interferences anticipated and encountered. Determine the exact routing and location of all systems prior to fabrication or installation. C. Priorities: Lines which pitch shall have the right of way over those which do not pitch. For example, plumbing drains shall normally have the right of way. Lines whose elevations cannot be changed shall have the right of way over lines whose elevations can be changed. D. Modifications: Offsets and changes of direction in all conduit systems shall be made as required to maintain proper headroom and pitch of sloping lines whether or not indicated on the drawings. Provide elbows, boxes, etc., as required to allow offsets and changes to suit job conditions. E. Replacement: All work shall be installed in a way to permit removal (without damage to other parts) of all other system components provided under this Contract requiring periodic replacement or maintenance. All conduits shall be arranged in a manner to clear the openings of swinging overhead access doors as well as ceiling tiles. F. Layout: The Contract Drawings are diagrammatic only intending to show general runs and locations of conduit and equipment, and not necessarily showing all required offsets, details and accessories and equipment to be connected. All work shall be accurately laid out with other Trades to avoid conflicts and to obtain a neat and workmanlike installation which will afford maximum accessibility for operation, maintenance and headroom. G. Contract Conflicts: Where discrepancies exist in the Scope of Work as to what Trade provides items such as starters, disconnects, flow switches, etc. such conflicts shall be coordinated between the divisions involved. It is the intent of the Contract Documents that all work shall be provided complete as one bid price. H. Drawing Conflicts: Where drawing details, plans or specification requirements are in conflict and where sizes of the same item run are shown to be different within the contract documents, the most stringent requirement shall be included in the Contract. Systems and equipment called for in the specification or as shown on the drawings shall be provided under the Contract of each trade as if it was required by both the drawings and specifications. Prior to ordering or installation of any portion of work. which appears to be in conflict, such work shall be brought to Architect's attention for direction as to, what is to be provided. I. Working Clearances: Working clearances about electrical equipment shall be as referenced in NEC 110, and shall include new equipment installed in existing ceiling spaces. J. Motor Circuits: Contractor shall coordinate circuit breaker, wire and conduit sizes with actual motors supplied. All changes required shall be made at no additional cost to the Owner. 1.13 DEMOLITION A. General: During the execution of the work, all required relocation, rerouting, etc., of existing equipment and systems in the existing building areas where the work is required, shall be performed by the Heartland Health Care Center of Zephyrhills-3181 16010-7 DE No 217032 38220 Henry Drive,Zephyrhills, FL 33542 Pending Emergency Rule 59A-4.1265