Laserfiche WebLink
GLAZED ALUMINUM CURTAIN WALLS <br />08 44 13 <br />SECTION 08 44 13 - GLAZED ALUMINUM CURTAIN WALLS <br />PART 1 GENERAL <br />1.01 SECTION INCLUDES <br />A. Aluminum -framed curtain wall, with vision glazing and glass infill panels. <br />1.02 SUBMITTALS <br />A. See Section 01 33 00 - Submittal Procedures. <br />B. Product Data: Provide component dimensions, describe components <br />within assembly, anchorage and fasteners, internal drainage details, <br />glazing, and infill. <br />C. Shop Drawings: Indicate system dimensions, framed opening <br />requirements and tolerances, affected related Work, expansion and <br />contraction joint location and details, and field welding required. <br />1. Shop drawings and related calculations for exterior installations are <br />to be prepared, signed, sealed and dated by an engineer <br />registered in the State of Florida using the wind pressures shown on <br />the Drawings and Chapter 16 of the Florida Building Code. <br />D. Test Reports: Submit results of full-size mock-up testing. Reports of tests <br />previously performed on the same design are acceptable. <br />E. Design Data: Provide framing member structural and physical <br />characteristics and engineering calculations, and identify dimensional <br />limitations; include load calculations at points of attachment to building <br />structure. <br />F. Report of field testing for air infiltration, water leakage and deflection. <br />G. Warranty: Submit manufacturer warranty and ensure forms have been <br />completed in Owner's name and registered with manufacturer. <br />H. Provide a Florida Product Approval for glazed aluminum curtain walls <br />including glazing meeting the required wind pressures. <br />I. Where required by authorities having jurisdiction provide a Miami -Dade <br />County Notice of Acceptance for glazed aluminum curtain walls. <br />1.03 QUALITY ASSURANCE <br />A. Designer Qualifications: Design structural support framing components <br />under direct supervision of a Professional Structural Engineer experienced <br />in design of this Work and licensed at the State in which the Project is <br />located. <br />Manufacturer and Installer Qualifications: Company specializing in <br />manufacturing aluminum glazing systems with minimum three years of <br />documented experience. <br />C. Pre -Installation Conference: The Contractor shall hold a pre -installation <br />conference at the job site with all trades affected by the work of this <br />AHCA # 23/100046-1 14 FLORIDA HOSPITAL - ZEPHYRHILLS 08 44 13 - 1 <br />HB #H-15027.00 ED EXPANSION & ORTHO RENOVATION <br />©HuntonBrady Architects, P.A. CONSTRUCTION DOCUMENTS O4.15.16 <br />CCD NO. 1 REVISION NO.2 07.15.16 <br />