07-6612 - Laserfiche WebLink

Browse Search

I , JELD-WE* : Wood - Premium Wood Exterior Doors - Entrance - Installation & Finishing Page 2 of3 unj:lven or blotchy after staining. if the door is to be stained, a wood Ciditioner or stain control should be applied prior to staining to promote a un form appearance and avoid sharp color contrasts or a blotchy ap earance. Note: as the sealer allows for even stain application, it also re uces grain contrast and the depth of stain penetration. If grain contrast is d ired a pre-stain sealer or wood conditioner should not be used. As with all finishes, test prior to application. Talk with a paint professional regarding thO application. A STAIN AND-CLEAR FINISHING 1. S in the door using a quality oil or alkyd-resin-based stain. 2. Fi ish the door with a quality exterior solvent-borne or waterborne p Iyurethane. Most quality exterior finishes require a minimum of two coats. R fer to finish manufacturer instructions. A marine-grade varnish is r commended on all wood exterior doors. N te: if a pre-stain sealer was not used, waterborne finishes increase the p tential of veneer splits and grain raise. 3. A I six sides must be finished prior to final installation to comply with rranty. 4. erior stain-and-clear finishes perform better if protected from sunlight and oisture. inspect finish once a year and refinish as needed. 5. atural grain and color variations are normal and not considered anufacturing defects. INSTALP.TtON AND MAINTENANCE B. PAINT FINISH I 1. eal door with a quality oil-based primer and two top coats of an exterior oil- ased or all-acrylic latex paint. 2. erior door finishes perform better if protected from sunlight and moisture. i spect finish once a year and refinish as needed. 3. II six sides must be finished prior to final installation to comply with arranty . Gaution JELD-WEN@ Premium Wood Doors can't evaluate all available paints, stains 0 application requirements. Consult your paint dealer for systems best suited f r your region and exposure. Always use top-quality finishes and follow instructi ns on finish labels. -AND-CLEAR FINISHING 1. inish the door with a quality solvent-borne or waterborne polyurethane. ote: if a pre-stain sealer was not used, waterborne finishes increase the tential of veneer splits, highlighted joints and grain raise. 2. II six sides must be finished prior to final installation to comply with arranty. 3. atural grain and color variations are normal and not considered ht1n. / /ip.l~-wen.com/attributes/text tmol.cfmlattribute id/3207 4/4/2007