11-12206 - Laserfiche WebLink

Browse Search

��.I�� .a 6.7 5 Prior to removal of release film, align sheets properly starting at the low-point of the roof (eave) with the selvage edge upslope and for minimum 2-inch overhang at eaves and rakes Remove the lower piece of release film and bond to substrate and fold the overhanging 2-inch over the eave and nail into place 12" o.c. Remove the top piece of release film and bond to substrate. Install primed drip edge and fasten to meet FBC Chapter 16 wind load requirements. Install 1/8-inch troweling of LeakBusterT`" MatrixT"' 201 Premium SBS Flashing Cement over drip edge. 6.7.8 Continue upslope in a similar manner, maintaining minimum 4-inch side-Iz�ps and minimum 6- inch end-laps. Ensure all end laps are staggered at least 3-feet apart. End laps shall be sealed with a 1/16 to 1/8� inch thick trowel application of LeakBusterT`" Matrix"" 201 Premium SBS Flashing Cement. 6.7.9 Use a hand roller to firmly bond side and end laps. 6.8 WeatherWatchp: 6 8 1 WeatherWatch shall not be left exposed for longer than 30-days after installation 6.8 2 WeatherWatch shall be installed in compliance with the requirements for ASTM D1970 underlayment in FBC Sections 1507 for the type of prepared roof covering to be installed 6.8.3 For tile roof installations governed by the FRSA/TRI 07320/8-05 Installation Manuai, Fourth Edition, use is limited to: � System 1, Option 5 or 6, Section 3.02E or F > System 2, Option 4 or 5, Section 3.02D or E 6.8.4 WeatherWatch� may be installed as a secondary water barrier using minimum 4-inch wide rolls to seal plywood deck joints prior to installation of the primary underlayment system 6.8.5 Back-nailing is required. Back-nailing shall consist of minimum 1-inch square or round cap nails spaced 18" o c within 3-inch side laps. 6.8.6 Prior to removal of release film, align sheets properly starting at the low-point of the roof (eave) with the selvage edge upslope and for minimum 2-inch overhang at eaves and rakes Remove the lower piece of release film and bond to substrate and fold the overhanging 2-inch over the eave and nail into place 12" o.c. Remove the top piece of release film and bond to substrate. Install primed drip edge and fasten to meet FBC Chapter 16 wind load requirements. Install 1/8-inch troweling of LeakBuster'"' MatrixT"' 201 Premium SBS Flashing Cement over drip edge 6 8 7 Continue upslope in a similar manner, maintaining minimum 3-inch side-laps and minimum 6- inch end-laps Ensure all end laps are staggered at least 18-inch apart. 6 8.8 Use a hand roller to firmly bond side and end laps Exterior Research and Design, LLC. Evaluation Report 01506.04.08 Certificate of Autho�ization #9503 FL10626 Date of Issuance: 04/25/2008 Page 7 of 9