My WebLink
|
Help
|
About
|
Sign Out
Browse
Search
12-12736
Zephyrhills
>
Building Department
>
Permits
>
2012
>
12-12736
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
1/25/2013 1:19:24 PM
Creation date
1/25/2013 1:16:36 PM
Metadata
Fields
Template:
Building Department
Company Name
FLORIDA HOSPITAL OF ZEPHYRHILLS
Building Department - Doc Type
Permit
Permit #
12-12736
Building Department - Name
FLORIDA HOSPITAL ZEPHYRHILLS
Address
7050 GALL BLVD
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
33
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
View images
View plain text
TrueA/arm Sensors - � • : • - - . . - - . <br /> � TrueAlarm photoelectric sensors use a stable,pulsed <br /> Sealed against rear air flow entry infrared LED light source and a silicon photodiode <br /> Interchangeable mounting receiver to provide consistent and accurate low power <br /> smoke sensing. Seven levels of sensitivity are available <br /> EMI/RFI shielded electronics for each individual sensor,ranging from 0.2%to 3.7%per <br /> Heat sensors: foot of smoke obscuration. Sensitivity is selected and <br /> • Selectable rate compensated,fixed temperature monitored at the fire alarm controJ.panel. <br /> sensing with or without rate-of-rise operation The sensor head design provides 360°smoke entry for <br /> • Rated spacing distance between sensors: optimum response to smoke from any direction.Due to its <br /> Fixed Temp. UL&ULC FM Spacing,Either Fixed photoelectric operation,air velocity is not normally a <br /> setting spacing Temperature setting factor,except for impact on area smoke flow. <br /> 135°F 60 ft x 60 ft 20 ft x 20 ft(6.1 m)for fixed <br /> (57.2°C) (18.3 m) temperature only;RTI=Quick �.- 4-7/8"(124 mm) -� <br /> 50 ft x 50 ft(15.2 m)for fixed � <br /> 155°F 40 ft x 40 ft temperature with either rate-of-rise <br /> (68°C) (12.2 m) selection,RTI=Ultra Fast 0.--LE=D status indicator <br /> Smoke Sensors: 2-��$" <br /> (54 mm) <br /> • Photoelectric or ionization technology sensing <br /> • 360°smoke entry for optimum response <br /> • Built-in insect screens <br /> � � ' � ' - • 4098-9714 Photoelectric Sensor with Base <br /> TrueAlarm heat sensors are self-restaring and provide rate � � ' : ' • - • • <br /> compensated,fixed temperature sensing, selectable with <br /> or without rate-of-rise temperature sensing.Due to its TrueAlarm Ionization sensors use a single radioactive <br /> small thermal mass,the sensor accurately and quickly source with an outer sampling ionization chamber and an <br /> measures the local temperature for analysis at the fire inner reference ionization chambet•to provide stable <br /> alarm control panel. operation under fluctuations in environmental conditions <br /> such as temperature and humidity. Smoke and invisible <br /> Rate-of-rise temperature detection is selectable at the combustion gases can freely penetrate the outer chamber. <br /> control panel for either 15°F(8.3°C)or 20°F(11.1°C) With both chambers ionized by a small radioactive source <br /> per minute.Fixed temperature sensing is independent of [pm 241 (Americium)],a very small current flows in the <br /> rate-of-rise sensing and programmable to operate at circuit. The presence of particles of combustion will cause <br /> 135°F(57.2°C)or 155°F(68°C).In a slow developing a change in the voltage ratio between chambers.This <br /> fire,the temperature may not increase rapidly enough to difference is measured by the electronics in the sensor <br /> operate the rate-of-rise feature However,an alarm will be base and digitally transmitted back to the control panel for <br /> initiated when the temperature reaches its rated fixed processing. <br /> temperature setting. <br /> Three levels of sensitivity are available for each <br /> TrueAlarm heat sensors can be programmed as a utility ionization sensor: 0.5,0 9,and 1.3`%per foot of smoke <br /> device to monitor for temperature extremes in the range obscuration. <br /> from 32°F to 155°F(0°C to 68°C).This feature can <br /> provide freeze warnings or alert to HVAC system �. aais°(124 mm) -� <br /> problems.Refer to specific panels for availability. — <br /> �� 4-7/8"(124 mm) -� � II��LED status indicator <br /> — 2-1/8" <br /> (54 mm) <br /> Q'F--LED status indicator <br /> 2-3/8" <br /> (60 mm) <br /> 4098-9717 lonization Sensor with Base <br /> � . . . <br /> Sensor locations should be determined only after careful <br /> 4098-9733 Heat Sensor with Base consideration of the physical layout and contents of the <br /> area to be protected.Refer to NFP�72,the National Fire <br /> Alarm Code�'.On smooth ceilings,smoke sensor spacing <br /> WARNING: In most fires, hazardous levels of smoke of 30 ft(9.1 m)may be used as a guide.For detailed <br /> and toxic gas can build up before a heat detection application information,refer to 4098 Detectors, Sensors, <br /> device would initiate an alarm. In cases where Life <br /> Safety is a factor,the use of smoke detection is highly and Bases Application Manual(574-709). <br /> recommended. <br /> 3 S4098-0019-12 8/2008 <br />
The URL can be used to link to this page
Your browser does not support the video tag.