Laserfiche WebLink
2.05 RACEWAY _ <br /> A. The following raceway types shall be permitted: <br /> 1. EMT conduit(3/4 inch minimum). <br /> 2 RIGID conduit(3/4 inch minimum). <br /> 3. Non-Metallic conduit for wet locations (3/4 inch minimum) <br /> 4 Surface mounted metallic raceway with a minimum size equivalent to three <br /> quarter(3/4) inch nominal conduit. <br /> B All raceway types shall be new. Installing used raceway is unacceptable. <br /> C Using existing raceway is unacceptable without prior written permission of the Engineer or <br /> Owner's Representative. <br /> D. Boxes, supports, and other accessories for the raceway installation shall be listed for the <br /> intended application <br /> PART 3 - EXECUTION <br /> 3 01 COORDINATION WITH OTHER TRADES <br /> A. Coordinate closely with all other trades to expedite construction, accurately interface with <br /> related systems and avoid interferences <br /> 3.02 INSTALLATION /APPLICATION <br /> A. Furnish and install all control wiring, raceway and outlet boxes for the fire alarm system <br /> B Furnish and install all backboxes, equipment and devices for the fire alarm system <br /> 1 Backboxes shall be of the exact type recommended by the FAEM as shown on <br /> the equipment and device submittals <br /> 2. Backboxes shall be instal�ed per the manufacturer's installation <br /> recommendations <br /> 3. Devices and equipment must be installed by personnel legally permitted and <br /> currently licensed to install the devices and equipment. The cost of installation, <br /> warranty of installation and equipment, coordination of the installation, and <br /> supervision of the installation are responsibilities of the Contractor. <br /> C A�I fire alarm junction boxes, pull boxes, cable splices and terminal cabinets shall be <br /> accessible, painted red or clearly marked "Fire Alarm" The Contractor shall comply with <br /> any local codes or AHJ requirements for circuit identification. Any access panels required <br /> for the accessibility to the junction boxes, pull boxes, cable splices and terminal cabinets <br /> shall be the responsibility of the Contractor <br /> Hobby Lobby—Zephyrhills, FL FIRE ALARM SYSTEM <br /> Issued for Permit—October 23, 2013 16720 - 12 <br />